Whilst charging, the status LED lights red and turns blue once
fully charged.
Ensure the output voltage from the USB port or the charger is 5V.
Charging voltage greater than 5V may damage the headphones.
5.2 Switch On / Off
Press the Power Button for 2 seconds to switch on the EP765. The
EP765 will enter reconnection mode and status LED will flashes blue.
Press and hold the Power Button for 3 seconds to switch off the EP765.
5.3 Bluetooth Connections
The EP765 will enter reconnection mode after switching on and will
connect to any previous known device automatically.
To pair to a new device, turn off the EP765 first then press and hold the
power button for 5 seconds to enter pairing mode. In pairing mode the
status LED will flash red and blue alternately.
- For mobile phones and tablets
1. Scan for available Bluetooth device on your mobile phone or tablets.
(Please consult your device’s user manual if necessary)
2. Select ‘EP765’ from the available devices and confirm the connection.
Some devices require a pin code. If this is the case, please enter the
code ‘0000’.
3. Once successfully connected, the status LED will lights blue slowly.
- For computers
1. Enable the Bluetooth function on your computer.
2. Select ‘Device and Printers’ from the Control Panel and click ‘Add a
Device’.
3. Select ‘EP765’ from the available devices, the system will install the
driver automatically. If a pin code is requested, please enter the code
‘0000’.
4. Once successfully paired and connected, the status LED will lights
blue slowly.
The EP765 could connect dual devices at the same time. After
connecting the first device, press and hold the Power Button for 3
seconds to switch off the EP765. Then press and hold the power button
for 5 seconds to enter pairing mode, and then connect second device
with EP765.
5.4 Noise Cancelling
Use the ANC switch to turn on / off the noise cancelling. The ANC
LED will light blue while ANC is enabled.
5.5 Audio – In
To use the EP765 as a pair of wired headphones, use a 3.5mm
audio cable to connect the EP765 to your source device. Once
the audio cable is connected to the EP765, the device switches
to wired mode automatically.
5.6 Remote Control
Button
Operation
Function
Play / Pause;
Pick up / Hang up a call
Power on / Off / Entering
Pairing Mode / Reject an
incoming call
Volume Up
Next track
Volume Down
Previous track
Press
Press and hold
Press
Press and hold
Press
Press and hold
+
+