Dynisco PT375 Transducer User manual

Type
User manual
P/N: 974063 | Rev: 100517 | ECO: 26555
www.dynisco.com
From lab to production,
providing a window into the process
-1-
Operating Manual
PT375 Flush Diaphragm High
Pressure Transducer
P/N: 974063 | Rev: 100517 | ECO: 26555
www.dynisco.com
From lab to production,
providing a window into the process
-2-
Introduction
The Dynisco model PT375 flush diaphragm pressure transducer
is designed to measure from 0 Ð 1000 psi up to 0 - 30,000 psi.
This model incorporates a 350-ohm, bonded foil strain gage
Wheatstone Bridge. This proven technology provides an
voltage output proportional to pressure (within the specified
error band). These transducers convert changes in applied
pressure into corresponding changes in voltage signals. These
output signals can be fed into a wide range of measurement
instrumentation with millivolt capability.
Pressure Fitting
The pressure fitting on the PT375 flush diaphragm pressure
transducer is a 3/4"-16 UNF-2A thread. The sealing surfaces
the 60û cone near the diaphragm, excluding the threads from
the wetted area.
The recommended mounting torque is:
50 ft-lbs.: Ranges ³ 20,000 psi
100 ft-lbs.: Ranges = 30,000 psi
Figure 1: PT375 Mounting Hole Diagram
Figure 2: PT375 Schematic
Function Pin
Color
Signal +
A Red
Signal -
B
Black
Excitation +
C
White
Excitation -
D
Green
Cal Signal
E, F Blue, Orange
.687
( 12.75 )
Ø
12.55
.
1
5
5
(3.94)
.150
.45
(11
.4
3)
.55
(13.97)
.38
2 47 ± 09
Layer 1
Wiring
All PT375s are equipped with a 6-pin, Bendix PT1H-
10-6P (or equal) receptacle. The suggested mating plug
is a Bendix PT06W-10-6S or equivalent, Dynisco P/N
711610. The PT375-0 has a six conductor integral
cable.
Figure 3: Wiring Codes for the PT375
Internal Shunt Calibration
Each transducer includes an internal shunt calibration
("R-Cal") function that is used to simulate a signal of 80%
full scale, this is achieved by crossing pins E and F. This
eliminates the need for cumbersome calibrated pressure
source when scaling associated instrumentation.
Transducer Repair
Questions concerning warranty, repair cost, delivery, and
requests for a RA# should be directed to the Dynisco Repair
Department, 508-541-9400 or email: repair@dynisco.com.
Please call for a return authorization number (RA#) before
returning any product. Damaged transducers should be
returned to:
Dynisco, LLC
Repair Department RA#
38 Forge Parkway, Franklin, MA 02038
Technical Assistance
Please call 800-221-2201 or 508-541-9400 or fax 508-541-
9436.
Warranty
This Dynisco product is warranted under terms and conditions
set forth in the Dynisco Web Pages. Go to www.dynisco.com and
click on Warrantyat the bottom of any page for complete
details.
  • Page 1 1
  • Page 2 2

Dynisco PT375 Transducer User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI