2063T

TradeQuip Professional 2063T Installation guide

  • Hello! I've reviewed the Setup Guide for the Transmission Lifter models 2022T and 2063T, and I'm ready to assist you with any questions. The document covers the process of assembling and levelling the lifter's legs, including initial wheel fitment, bolt tightening, and weight assisted levelling. Feel free to ask about specific steps or clarify any part of the instructions.
  • How should the legs be positioned initially for setup?
    When should the leg bolts be fully tightened?
    How much weight is recommended for leveling the legs?
    What should be done after the unit's bolts are lightly tightened?
www.tqbbrands.com.au Apr23
Setup Guide
Leg Levelling
Transmission Lifter
Product Codes: 2022T & 2063T
TRANSMISSION LIFTER LEG LEVELLING
1. Once you have securely fitted the wheels to the legs, place the legs upside
down so the bottom bolts can be installed.
2. Once the nuts & bolts are in place, lightly tighten so the legs are secured into
place. Legs can be fully tightened at the end.
3. Now that the 3 bolts underneath have been lightly fastened, flip the legs over
and place the Transmission Lifter ram onto the leg base & match up with the
bolt holes.
4. Lightly tighten all three bolts that hold the ram onto the leg base.
5. Now that the unit has all its bolts lightly tightened, to correctly level the legs,
we recommend securely adding no more than 50-60kg of weight to the
transmission lifter headstock on a flat surface. This will allow the legs to settle
into position. Start by tightening the 3 side clamping bolts evenly to allow the
legs to come together resulting in the legs being evenly levelled.
6. Lastly tilt the jack on its side and tighten the leg frame bolts.
To correctly set up your TradeQuip Transmission Lifter so it is ready to go into service, the following steps need to
be taken:
/