SQUARE INSIDE
LEFT: NOTCH OUT
BACK CORNER
“SOFT” OUTSIDE
SQUARE OUTSIDE
This tool works best on soft woods such as pine or MDF.
Hardwoods like oak have hard spots that can break blades.
Cut with bottom handle grip against floor for increased
leverage and support. Commit and cut all the way through.
Partial cuts get stuck on blade. Do not twist the wood off.
Most cuts are made with radius facing the blade (exception:
square inside corner).
45º
45º
45º
22.5º
22.5º
22.5º
22.5º
22.5º
45º
LEFT
LEFT
RIGHT
RIGHT
LEFT
RIGHT
CENTER
RIGHT
LEFT
RIGHT
RIGHT
RIGHT
LEFT
CENTER
LEFT
LEFT
LEFT
RIGHT
CENTER
RIGHT
LEFT
RIGHT: NOTCH OUT
BACK CORNER
TIP: NOTCHED BACK CORNERS
ELIMINATE GAPPING
MITER CORNERS:
MOST CUTS -
RADIUS
FACES
BLADE:
REMOVELAY FLAT ON
WALL SIDE
LAY FLAT
ON WALL
SIDE
REMOVE
22.5º
1
1
2
3
4
2
1
2
3
4
No. 855 Wood Mitre
Instructions For Use
REPLACEMENT PARTS:
NO. 855 WOOD MITER
Order No. Description
856 Wood Miter Replacement Blade
1855-A Table & Screw
1880-N Nut, Bolt, Bushing Set
856
N
N
A
BLADE CHANGE:
WARNING: blades are sharp!
PULL
OUT
NUT
BOLT
BUSHING
PUSH OUT
BUSHING
PULL OUT
BLADE
BOTTOM
HANDLE
BOTTOM
HANDLE
Push out blade bushing
from bottom handle
and pull blade out.
Insert new blade, and replace bushing.
Replace bottom handle. Re-insert
carriage bolt, and tighten nut.
Remove nut and
carriage bolt.
1.
Pull bottom
handle out.
2.
3.
4.
/