G Series

cantaloupe G Series User manual

Hello! I've reviewed the instructions for installing the cantaloupe high-gain antenna. This document details the step-by-step procedure, from preparing the location to securing the cable, ensuring optimal signal reception. I'm here to answer any questions you have about the installation process or specific steps mentioned in the manual.
What tools are required for the installation?

Where should the antenna be placed?

What is the correct way of cable installation?

INSTALLING A

HIGH-GAIN ANTENNA

Tools Required

Need some help?

1

• Power drill

• Metal auger drill bit with a 7/16"

setting

• Slip-joint pliers

•Tape or tie-wraps for

the cable

2

Drill a 7/16" hole with an auger

bit from the top of the door or

frame.

3

Place the cable and the

antenna base with the

rubber gasket into the hole

from the top. Place the

star washer on the base,

and tighten the nut until

the star washer ﬁrmly

contacts the metal casing

for grounding.

4

Thread it through the

rubber grommet and

hole, then attach it to

the back of the card

reader. DO NOT BUNDLE

OR COIL THE CABLE.

5

Tape or tie down the cable so that the

door does not pinch or crimp it.

To access an online version

of these instructions, scan

the QR code.

Phone: +1 888.561.4748

Email: [email protected]

Place the antenna in a

location near the card

reader but away from

electronic devices,

including ﬂuorescent

lights, motors, and

transformers.

Rubber Gasket

Star Washer

Hex nut

Door or case frame

Antenna

Attach

antenna

cable

/

Other documents