Features
•
Compression molded from our exclusive solid Vikrell
®
material
•
Tongue-and-groove 4-piece modular design allows for
easy ″snap together″ installation
•
Integral apron with removable access panel
•
Durable high-gloss finish
•
Pump with air switch and grounding-type plug-in cord
•
6 Jets
•
10-year consumer/3-year commercial limited warranty
•
Three-piece wall set with generous storage shelves
•
16″ (40.6 cm) whirlpool bath depth (floor to top of
threshold)
•
60-1/4″ (153 cm) x 43-1/2″ (110.5 cm) x 73-1/4″
(186.1 cm) complete unit rough-in dimensions include
flange
•
60″ (152.4 cm) x 42″ (106.7 cm) x 72″ (182.9 cm)
complete unit finished dimensions
Codes/Standards Applicable
Specified model meets or exceeds the following:
•
ASME A112.19.7M
•
ANSI Z124.1.2
•
NAHB Research Foundation, Inc.
•
ASTM E162
•
ASTM E662
•
HUD, UM Bulletin 73A
•
UL 1795
42″ (106.7 cm) WHIRLPOOL BATH
AND WALL SURROUND
76110110
ALSO 76110120
Colors/Finishes
•
0: White
•
Other: Refer to Price Book for additional colors/finishes
Specified Model
Model Complete Unit Description Colors/Finishes
76110110 42″ (106.7 cm) whirlpool bath and wall surround, left drain ❑ 0 ❑ Other_____
76110120 42″ (106.7 cm) whirlpool bath and wall surround, right drain ❑ 0 ❑ Other_____
Model Wall Component Description Colors/Finishes
71112100 Back wall ❑ 0 ❑ Other_____
71113110 Left end wall ❑ 0 ❑ Other_____
71113120 Right end wall ❑ 0 ❑ Other_____
71114100 Complete wall set ❑ 0 ❑ Other_____
71115100 End wall set ❑ 0 ❑ Other_____
ENSEMBLETM
Page 1 of 2
1016902-4-
J
For more information
visit SterlingPlumbing.com
or call 1-800-STERLING
Technical Information
Fixture*:
Basin area:
Bathing well 40″ (101.6 cm) x 27″ (68.6 cm)
Top area 52″ (132.1 cm) x 35″ (88.9 cm)
To overflow:
Water depth 11″ (27.9 cm)
Capacity 55 gal (208.2 L)
* Approximate measurements for comparison only.
Pump: V Hz A
1-speed 120 60 7
Model Door maximum
width
Door maximum
height
76110110
76110120
58″ (147.3 cm) 56″ (142.2 cm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump 120 V, 15 A, 60 Hz
Installation Notes
Install this product according to the installation guide.
Pump is supplied with a grounding type plug-in cord. Locate
the outlet behind the whirlpool, and within 24″ (61 cm) of the
pump.
Do not disassemble the pump or piping as this could void the
warranty.
Size the drain cutout to fit the drain assembly that will be
used.
End stud positioning is critical if apron nailing-in flanges are to
be used.
Studs should be positioned roughly as shown.
3-1/2" (8.9 cm)
30" (76.2 cm)
Drain Cutout
3-1/8" (7.9 cm)
60-1/8" (152.7 cm) Min
60-1/4" (153 cm) Max
Pump Motor
Location
43-1/2"
(110.5 cm)
20-1/4"
(51.4 cm)
11-1/2"
(29.2 cm)
16"
(40.6 cm)
14"
(35.6 cm)
6" (15.2 cm)
(Typical)
4"
(10.2 cm)
8"
(20.3 cm)
27-1/2"
(69.9 cm)
42"
(106.7 cm)
43-1/2"
(110.5 cm)
Overflow Detail
1-1/4"
(3.2 cm)
53"
(134.6 cm)
3"
(7.6 cm)
73-1/4"
(186.1 cm)
16"
(40.6 cm)
60"
(152.4 cm)
1-1/2"
(3.8 cm)
19"
(48.3 cm)
20"
(50.8 cm)
8-3/4"
(22.2 cm)
2" (5.1 cm) D.
Drain
Product Diagram
ENSEMBLETM
ENSEMBLETM 42″ (106.7 cm) WHIRLPOOL BATH AND WALL SURROUND
Page2of2
1016902-4-
J
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Sterling 72141110 User manual
-
-
-
-
-
-
-
-
Sterling 71101320-LNR-0 User manual
-
Other documents
-
Sterling Plumbing Hot Tub 76111120 User manual
-
-
-
-
-
-
-
-
-