“Gun Master 300”
F-15-617
July, 2000
These instructions are for experienced operators. If you are not fully familiar with the principles of operation and
safe practices for arc welding equipment, we urge you to read our booklet, “Precautions and Safe Practices for
Arc welding, cutting and gouging,” form 52-529. Do NOT permit untrained persons to install, operate, or main-
tain this equipment. Do NOT attempt to install or operate this equipment until you have read and fully understand
these instructions. If you do not fully understand these instructions, contact your supplier for further informa-
tion. Be sure to read the Safety Precautions before installing or operating this equipment.
Be sure this information reaches the operator.
You can get extra copies through your supplier.
0558001591 Gun Master 300cc 15 ft 035-045
Same as:
0558001649 Gun Master 250cc 15 ft X 035-045
Cable assembly P/N 952957, Replaces Item 10B Page 18.
(All other replacement and consumable parts remain the same).
Refer to F-15-612 for Assembly, Operation, Parts, and Maintenance.
This manual provides complete instructions for the following unit:
/
