Brodit 854971 Datasheet

Product 854971

854971 ProClip

Angled mount

The ProClip is a mounting bracket for the vehicle's dashboard. Onto the ProClip you can install e.g. a holder for

your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is

car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required

and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.

EAN: 7320288549712

Item no 854971 fits:

Peterbilt Model 357 07-12 (For USA)

Peterbilt Model 378 07-12 (For USA)

Peterbilt Model 379 07-12 (For USA)

Peterbilt Model 385 07-12 (For USA)

1(2)

1. 2.

INSTALLATION INSTRUCTIONS

4.3.

Please read the instructions and look at the pictures before attaching the ProClip.

1. Press the thin end of the enclosed gap opener into the gap between the center console panel panel and the

narrow trim. Then gently pull out to loosen the panel, and remove it. Remove the screw under the panel. Use the

thin end of the gap opener to loosen the panel.

2. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape

cover on the ProClip. Hook the curved edge over the panel edge. Press firmly down on top of the ProClip so the

angled edge on the lower part hooks around the panel edge. Push the panel back into place.

3. Secure the panel with the removed screw. Pop the narrow trim back into place.

4. The ProClip is in place.

2(2)

Download PDF