Panasonic ES-2401 Owner's manual

Before operating this unit, please read these instructions completely.

Operating Instructions

Model No. ES2401

Manicure Care

0

Page is loading ...

4

the on/off switch to “1” position

for low speed, and “2” position

for high speed setting.

To reduce the risk of injury to

cuticles only use the cuticle

attachment with “1” position (low

speed). “2” position (high speed)

is recommended for smoothing

and finishing. Filing can be safely

done on either speed.

For best results, please place your

fingers on a table so that they

will not move during operation.

Smart ways to use

Filing (Fig. 4)

Use this attachment to shape your

nails.

Move the switch to the “1” or “2”

position then hold the file to your

nail at a 45

o

angle as shown.

Cuticle care (Fig. 5)

Use this attachment to push the

cuticle.

Move the switch to the “1” position

and place the side of the tip to the

cuticle.

NOTE:

Although it is best to file the nails

while they are dry, cuticles respond

best immediately after bathing or

soaking in warm water.

Coarse (pink) (Fig. 6)

Use this attachment to smooth

ridges and imperfections on the nailʼs

surface.

Move the switch to the “2” position

before placing the pink side against

Parts identification (Fig.1)

On/off switch

0 off

1 low speed

2 high speed

Battery cover

Attachment stem

Filing attachment

Cuticle care attachment

Polishing attachment

Coarse (pink)

Finishing (white)

Soft pouch

Replacement finishing (white)

seals × 1 piece

BEFORE USAGE PLEASE READ

THE MANUAL CAREFULLY AND

COMPLETELY.

Inserting the batteries

(Fig. 2)

Remove the battery cover.

Insert two AAA (LR03) alkaline

batteries.

Replace the battery cover.

• Make sure the batteries match the

+ and – markings.

• Do not mix old and new batteries or

use rechargeable batteries.

• Remove the batteries when not

using the product for a long time.

How to use

1) Insert the attachment on the

attachment stem until it clicks in

place. (Fig. 3)

Please refer to “Smart ways to

use” to select the appropriate

attachment.

2) Turn the product on by sliding

5

the nailʼs surface to smooth.

Finishing (white) (Fig. 6)

Use this attachment to polish the

nailʼs surface.

Move the switch to the “2” position

before placing the white side

against the nailʼs surface. Move it

horizontally to polish the entire nail.

NOTE:

It is our recommendation that the

coarse attachment (pink) be used

approximately twice a month and

the finishing attachment (white)

once a week. More frequent use

may weaken the nail.

Using self-adhesive replacements

(Fig. 7)

Before using a new self-adhesive

replacement, wipe the attachment

clean with a lint-free cloth.

Replacement seal sets

(Sold separately)

• Filing seals: 2 pieces

• Polishing seals

Coarse (pink) : 1 piece

Finishing (white): 2 pieces

Caution:

• Use this product only for its

intended use, as described in this

manual.

• Do not overuse the coarse

attachment. It may weaken the

nails.

• Attachments will last longer if nails

are clean before use.

• Do not cut nails too closely or

over-press the cuticle-injury may

result.

• A solid surface is best for an error-

free manicure.

• If the surface of the attachment

comes into contact with water; oil

or the nail surfaces are wet, the

effectiveness of the attachments

may be permanently reduced.

Always use with clean, dry hands.

• During use, do not apply force on

the attachment to the extent that

its movement might be prohibited.

Malfunction or injury to the nail

may result.

• Do not wash the main body with

water.

In addition, do not store this product

in places with high humidity (such

as the bathroom and etc.).

• Clean the main body by a clean,

dry, lint-free cloth.

Do not use solvents or harsh

cleaners.

• Remove any dirt on the product

using a cloth moistened with

soapy water. Do not use thinner or

benzine.

• A damaged or defective product

should be returned to a customer

service center or to an authorized

customer service agent.

Do not attempt to use this product

if defective or try to repair it

yourself.

Specifications

Power supply: Batteries

Battery size : Two AAA (LR03)

alkaline batteries

(Sold separately)

Weight : 85

(including batteries)

6

Airborne Acoustical Noise:

60 (db(A) re 1pw)

Information on Disposal

for Users of Waste Electrical

& Electronic Equipment

(private households)

This symbol on the prod-

ucts and/or accompany-

ing documents means

that used electrical and

electronic products

should not be mixed with

general household waste.

For proper treatment, recovery

and recycling, please take these

products to designated collection

points, where they will be

accepted on a free of charge basis.

Alternatively, in some countries

you may be able to return your

products to your local retailer upon

the purchase of an equivalent new

product.

Disposing of this product correctly

will help to save valuable resources

and prevent any potential negative

effects on human health and the

environment which could otherwise

arise from inappropriate waste

handling. Please contact your local

authority for further details of your

nearest designated collection point.

Penalties may be applicable for

incorrect disposal of this waste,

in accordance with national

legislation.

For business users in the European

Union

If you wish to discard electrical

and electronic equipment, please

contact your dealer or supplier for

further information.

Information on Disposal in other

Countries outside the European

Union

This symbol is only valid in the

European Union.

If you wish to discard this product,

please contact your local authorities

or dealer and ask for the correct

method of disposal.

Page is loading ...

Panasonic ES-2401, ES2401 Owner's manual

Related papers

Other documents