Matsui MCH60BLK Instruction book

Brand: Matsui

Model: MCH60BLK

Category: Cooker hoods

Type: Instruction book

This manual is also suitable for

MCH90SS

Instruction Book

Cooker Hood

Model MCH60SS / MCH90SS/ MCH60BLK/ MCH90BLK

MCH60SS cooker hood D4.qxd 9/29/05 4:39 PM Page 1

Cod:0103071747

• The appliance must be installed according

to the manufacturer’s instructions.

Improper installation may result in injury

or damage, for which the manufacturer

cannot be held responsible.

• The electrical safety of this appliance is

guaranteed only if it is connected to a

properly earthed system which complies

with the electrical safety standards in

force. If you cannot verify that this

fundamental safety requirement is in

place, consult a qualified electrician.

The manufacturer cannot be held

responsible for an appliance which has

not been correctly earthed.

• Check that the voltage (230 Volts AC)

printed on the rating label at the back of

the Cooker hood corresponds to the mains

voltage in your home. If in doubt call a

qualified electrician.

• Never replace the power supply cable

yourself. Damaged cables must only be

replaced by an authorised service centre.

Safety

WARNING!

It is hazardous for anyone other than authorised

service personnel to carry out Servicing or

repairs which involves the removal of covers.

To avoid the risk of an electric shock do not

attempt to repair this appliance yourself.

Disposal

Old appliances still have some residual value.

An environmentally friendly method of

disposal will ensure that valuable raw materials

can be recovered and used again. Up to date

information concerning options for disposing of

your old appliance and packaging from the

new one can be obtained from your local

council office.

• Adaptors, multiple sockets and/or

extension leads must not be used.

• To avoid electrical shock, never touch the

Cooker hood or plug with wet hands.

• Ventilation outlets on the Cooker hood

should never be covered, as obstructions

may cause overheating or fire.

• Always disconnect the plug from the

mains supply before cleaning the Cooker

hood or carrying out maintenance work.

• Do not flambé under the Cooker hood as

this may cause a fire hazard.

• Avoid leaving a gas hob on when there is

no pan on the stove.

MCH60SS cooker hood D4.qxd 9/29/05 4:39 PM Page 2

WARNING-Please be careful when unpacking and installing this appliance

as sheet metal can cause injury if not handled with care.

Installation

Before beginning any installation work ensure

the mains power has been turned off.

Ducting

1 Using a Phillips screwdriver fix the ducting

hose connector onto the air outlet of the hood.

2 Connect the hose to the air duct.

Use the adaptor provided to connect

to a 125mm hose.

3 The ducting can pass through your wall.

Alternatively if your kitchen has a soffit,

then the ducting can be positioned to run

horizontally through an outside wall

directly to a wall cap.

NOTE: A soffit is the underside of the roof

overhang, normally wood or plastic.

Stencil

Use the stencil provided to help position the

hood onto the wall directly below the ducting.

NOTE: Take extreme care when drilling holes

into your wall to avoid hidden electrical wiring.

1 With the stencil positioned on the wall,

drill 4 holes onto the back wall. Push 4

raw plugs into the drill holes and then first

screw in the top 2 screws.

2 Fix the hood onto the wall by positioning

the upper 2 screws through the key holes

on the back of the hood.

3 Attach the lower part of the hood by

removing the filter panels to gain access

to the lower screw holes.

Attaching the Chimney flue wall bracket

1 Using the wall bracket as a template, drill

2 holes into the wall and push raw plugs

into the drill holes.

2 Place the wall bracket over the raw plugs

and screw into position.

3 Screw the inner chimney flue section to the

wall bracket.

Adjusting the telescopic hood

The telescopic chimney flue can be adjusted in

height to fit your ceiling once fully attached to

the wall.

MCH60SS cooker hood D4.qxd 9/29/05 4:39 PM Page 4

Re-Circulation using Carbon filters

Two carbon filters can also be added to your

Cooker hood, when air is to be re-circulated

instead of external ducting. Attach to either

side of the motor.

Please see the Partmaster Direct details on the

back cover to order one.

(2 carbon filters required)

Installation

Carbon filter

Attaching

the Carbon

filter

Control panel

0 = Switches the Cooker hood off.

1 = Low speed. Is suitable when low levels of

steam are created whilst cooking.

2 = Medium speed.

3 = High speed. Is suitable when high levels

of steam are created whilst cooking.

= Switches the overhead light on.

The Cooker hood should be left on for at least

15 minutes after cooking has finished to ensure

efficient filtering of the air.

Regular cleaning will help to maintain the

effectiveness of your Cooker hood.

1 Switch off and unplug the Cooker hood

before cleaning.

2 Clean the outside of the Cooker hood with

a damp cloth and a mild detergent.

NOTE: Do not use solvents or abrasives as this

may damage the Cooker hood.

Cleaning

In Use

MCH60SS cooker hood D4.qxd 9/29/05 4:39 PM Page 5

To ensure the filters do not become a fire

hazard we recommend they are washed every

3 months. Do not check the filter panels whilst

the Cooker hood is in use.

1 Before cleaning the filters always switch

off and disconnect the electrical supply.

2 Remove the filter panels by holding down

the buttons on each panel and lifting

towards you. They can then be taken out

of the cooker hood.

3 Wash each filter in warm water and a

mild detergent, leave to soak and drain.

Ensure it is completely dry before

replacing into the Cooker hood.

4 Place the bottom of each panel into the

back of the Cooker hood and raise the

top to click into position.

NOTE: The filter panels are also dishwasher

proof. The filter panels may alter in colour

slightly after several washes, this is not a fault.

Cleaning the filters

Changing the internal light

Allow the Cooker hood to cool for at least

30 minutes after use before changing the

light bulb.

1 Before carrying out the bulb replacement

always switch off and disconnect the

electrical supply.

2 Remove the removable filters by holding

down the buttons on each panel and

lifting towards you. They can then be

taken out of the Cooker hood.

3 Remove the old bulb by unscrewing it in

an anti-clockwise direction.

4 Replace with a new bulb (maximum 40w)

by screwing it in a clockwise direction.

Make sure that it is secure in the bulb

holder (your cooker hood is fitted with

2x 40w bulbs).

5 Replace the filters.

The Cooker hood is not working

• Check it is plugged in and switched on.

• Check that the fuse in the plug has

not blown.

• Plug in another appliance, such as a

lamp, to see if the socket is working.

Servicing

Only an authorised, qualified technician

should perform repairs and maintenance of

the appliance.

Maintenance and Troubleshooting

MCH60SS cooker hood D4.qxd 9/29/05 4:39 PM Page 6

Model

Rated Voltage 230 230

(V)

Rated Frequency 50 50

(Hz)

Rated Power 160 160

(W)

Weight 9.5 12

(kg)

Product Dimension

h/w/d 26x60x50 28x90x50

(cm)

Bulbs 2x40W max 2x40W max

(E14)

Weight and Dimensions are approximate. Because we continually

strive

to improve our products we may change specifications and

designs

without prior notice.

Technical specifications

If the colours of the wires in the mains lead of this appliance do not

correspond

with the coloured markings identifying the terminals in

your

plug, proceed as follows:

The

wire which is coloured Green and Yellow MUST be connected

the terminal which is marked with the letter E (Earth) or symbol

coloured Green. The wire which is coloured Blue MUST be

connected

to the terminal which is marked with the letter N or

coloured

Black. The wire which is coloured Brown MUST be

connected

to the terminal which is marked with the letter L or

coloured

Red.

Before

refitting the plug cover, check that there are no cut or stray

strands

of wire inside the plug. Use a 13 Amp BS1362 fuse, only

BSI

or ASTA approved fuses should be used. If you are in any way

unsure

which plug or fuse to use, always refer to a qualified

electrician.

Note:

After replacing or changing a fuse on a moulded plug which

has

a fuse cover, the cover must be refitted to the plug, the

appliance

must not be used without a fuse cover. If lost,

replacement

fuse covers can be obtained from an electrical shop.

This

appliance complies with the following EEC Directives:

73 / 23 EEC (Low Voltage Directive)

89 / 336 EEC (EMC Directive).

THIS APPLIANCE MUST BE EARTHED.

This

appliance is fitted with a fused three pin plug to BS 1363

which

will be suitable for use in all houses fitted with sockets to

current

specifications.

If the fitted plug is not suitable for your socket outlets, it should be

cut off and carefully disposed of. To avoid a possible shock

hazard,

do not insert the discarded plug into a socket.

Fitting a new plug

If for any reason you need to fit a new plug, the flexible mains lead

must be connected as shown here. The wires in the mains lead fitted

this appliance are coloured in accordance with the following code:

CONNECT GREEN AND YELLOW TO EARTH (E)

CONNECT

BLUE TO

NEUTRAL (N)

MAKE

SURE THE OUTER

SHE

ATH OF THE MAINS

LEAD

IS SECURELY HELD

BY THE CLAMP

CONNECT

BROWN

LIVE (L)

113 AMP FUSE

Electrical information

MCH60SS cooker hood D4.qxd 9/29/05 4:39 PM Page 7

MCH60SS MCH90SS

MCH60BLK

MCH90BLK

V4 08/06

Visit Partmaster.co.uk today for the easiest way to buy electrical spares and accessories.

With over 1 million spares and accessories available we can del iver direct to your door the

very next day.

Visit www.partmaster.co.uk

or call

0870 6001 338

(UK customers only)

Calls charged at National Rate.

MCH60SS cooker hood D4.qxd 9/29/05 4:39 PM Page 8

This symbol on the product or in the instructions means that your electrical and electronic equipment

should be disposed at the end of its life separately from your household waste. There are separate

collection systems for recycling in the EU.

For more information, please contact the local authority or your retailer where you purchased the

product.

Matsui MCH60BLK Instruction book

Brand: Matsui

Model: MCH60BLK

Category: Cooker hoods

Type: Instruction book

This manual is also suitable for

MCH90SS

Download PDF

report

Matsui MCH60BLK Instruction book

This manual is also suitable for

Matsui MCH60BLK Instruction book

Related papers

Other documents