T
he water level can be set to match your
preference.
For the “DRY” course, only “22L” and “32L(31L)” are
a
vailable. [( ): BW-D6LV water level]
When you add water during washing and rinsing, press
the “WATER LEVEL” button. During press the button,
water is supplied.
(Water is not supplied above the maximum water level
of each course.)
Changing the water level:
Remaining, Reservation time
and Alert displays indication:
A
fter operation starts, remaining time will be
displayed.
Each time the RESERVE button is pressed, the
reserved operation end schedule time is
displayed.
After reserved operation starts, only “RESERVED”
lights.
Used to set the “WASH”,
“RINSE”, “SPIN”, or “DRY”
operation contents, or to
change the combinations.
After starting, change by pressing
“PAUSE”. Cannot be changed after
the end of the “WASH” operation.
Settings of some courses cannot
be changed.
Changing operation
contents:
Start / Pause:
Used to start or pause the
operation.
Even if “PAUSE” is pressed during
operation, the lid cannot be opened
until the wash and spin tub stops
rotating.
During drying, the lid will not open,
even if “PAUSE” is pressed, until
temperature inside wash and spin
tub has cooled down.
By pressing the “WATER PUMP”
button, processes in which water
remaining in bath can be used will be
lit in sequence.
W
hen not using bath tub water, turn off all
the displays by pressing the button.
The “DRY” course, “DRYING” course, and
clean “DEODORANT/STERILIZATION”,
“POLLEN”, and “TUB DRYING” courses
cannot be set.
Using bath tub water:
Lights steadily or blinks when
the wash and spin tub reaches
a high temperature.
High temp
Blinks when the dry filter
becomes clogged.
Filter
The lamp remains while the lid
i
s locked.
(Lid lock)
Alert displays: Reservation:
A
n operation end time from
3 to 12 hours later can be
reserved in 1 hour units.
W
ashing “BLANKET” and
“DRY” courses and “DRY” and
“CLEAN” operations and HOT
CLEANING cannot be
reserved.
Each time “WASH”, “WASH
DRY”, “DRY”, or “CLEAN”
button is pressed, the courses
which can be selected will be lit
in sequence.
Selectable courses will vary
depending on “WASH”, “WASH
DRY”, “DRY”, and “CLEAN”
modes.
Selecting course: Using HOT CLEANING:
The detergent is activated by
blowing hot air onto the
laundry.
Cannot be changed at “BLANKET”
and “DRY” courses and “DRY”,
“CLEAN”, and “RESERVED”
operations.
Used to turn the unit ON/OFF.
If the machine is not started within
5 minutes after the power is turned
on, the power is automatically
turned off.
When the operation is complete,
the power will automatically turn
off.
Power:
The operation panel of the
BW-D7LV is described.