4
4.4 Automatic
Bluetooth
®
connection (after
successful pairing)
• Make surethat your
Bluetooth
®
capable terminal
device is on and
Bluetooth
®
is activated.
• Make surethat the speaker is located within the
Bluetooth
®
range of max. 10 metres.
• Switch on the speakers as described in
4.1
Switching the product on and off.
• After successful connection, the status LED (8) will
light up in blue. An acoustic signal conrms that
connection was successful.
Note –Connection impaired
• After the speaker and terminal device have been
paired, aconnection is established automatically.
If the
Bluetooth
®
connection is not established
automatically,check the following:
• Check the
Bluetooth
®
settings of your terminal
device to see whether Hama Gentleman-M is
connected. If not, repeat the steps listed under
Bluetooth
®
pairing.
• Check whether your terminal device and the
speaker areless than 10 metres apart. If not, move
them closer together.
• Check whether obstacles areimpairing the range.
If so, move the devices closer together.
4.5 Audio playback (via
Bluetooth
®
)
Start and control audio playback on the connected
terminal device accordingly.Alternatively,audio
playback can also be controlled on the speaker (if the
connected device supports this function).
• Press the ►
function button (5) to start or pause
audio playback.
• Brieypress the +function button (6) to skip to the
next track.
• Brieypress the –function button (4) to go back to
the previous track.
• Hold down the +function button (6) to increase the
volume.
• Hold down the –function button (4) to reduce the
volume.
4.6 MP3 audio playback (via microSD card media
player connection)
The speaker can also play MP3 audio les from microSD
cardstorage media.
• Insert amicroSD cardinto the microSD cardslot under
the cover (2). The speaker automatically switches to
media player mode.
• Press the
►function button (5) to start or pause
audio playback.
• If you want to remove the microSD card, pause
playback rst; then take out the microSD card.
4.7 Hands-free function
Youcan use the speaker as ahands-free set for your
mobile phone. Forthis function, the mobile phone must
be connected to the speaker via
Bluetooth
®
.
• Press the function button
(7) once to answer an
incoming call.
• Press and hold the function button (7) for approx. 2
seconds to reject an incoming call.
• Youcan put acallonhold by pressing and holding
the function button
(7) for approx. 2seconds.
• Press and hold the function button (7) again to
continue the call.
• During acall, press the function button (7) once to
end the call.
Note –Call quality
To increase the callquality,make surethat you are
near the speaker with your mobile phone during the
call.
5. Operation –NFC connection
Note
• To be able to connect your terminal device to
the speaker using NFC, your terminal device
must be compatible with NFC technology.For
moreinformation, please refer to the operating
instructions of your terminal device.
• Note that the presence of mobile phone cases,
covers or other materials between the speaker and
the back of your terminal device can interferewith
connection or even prevent it.
• Note that NFC has ashort transmission range of
about 10 cm.