CURT 112893 Installation guide

Type
Installation guide

CURT 112893 is a weight-carrying hitch that is designed to be used with a 2000-2005 Toyota Celica or 2000-2005 Echo. It has a gross load capacity of 2,000 lbs and a 200 lbs tongue weight. The hitch is easy to install and does not require any drilling. It comes with all the necessary hardware and can be installed in about 20 minutes. The hitch is perfect for carrying bikes, kayaks, or other gear. It is also great for towing small trailers.

CURT 112893 is a weight-carrying hitch that is designed to be used with a 2000-2005 Toyota Celica or 2000-2005 Echo. It has a gross load capacity of 2,000 lbs and a 200 lbs tongue weight. The hitch is easy to install and does not require any drilling. It comes with all the necessary hardware and can be installed in about 20 minutes. The hitch is perfect for carrying bikes, kayaks, or other gear. It is also great for towing small trailers.

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT
1-800-798-0813
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
2,000 200
22
10
10/1/2012
11289
20
24694 / 247388
EXCLUDES ACTION PACKAGE
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLTM10-1.25 x 3541
CONICAL TOOTHED WASHER3/8"42
EXISTING WELDNUTS
FRAME RAILS
1. Under the vehicle, locate and remove the left and right tie-down brackets and return to vehicle's
owner.
2. Hitch will mount in place of the tie-down brackets. Use four fastener sets to mount hitch at
existing weldnuts where brackets were removed.
3. Torque all fasteners to 48 ft-lb.
TOOLS REQUIRED
14mm SOCKET
17mm SOCKET
12" EXTENSION
RATCHET
TORQUE WRENCH
2
1
2000-2005 TOYOTA CELICA & 2000-2005 ECHO
-NO DRILLING REQUIRED
-REMOVE TIE DOWN BRACKETS
FRAME RAILS
DESIGNED FOR USE WITH
BALLMOUNT #55001 / 45501
  • Page 1 1

CURT 112893 Installation guide

Type
Installation guide

CURT 112893 is a weight-carrying hitch that is designed to be used with a 2000-2005 Toyota Celica or 2000-2005 Echo. It has a gross load capacity of 2,000 lbs and a 200 lbs tongue weight. The hitch is easy to install and does not require any drilling. It comes with all the necessary hardware and can be installed in about 20 minutes. The hitch is perfect for carrying bikes, kayaks, or other gear. It is also great for towing small trailers.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI