Ideaworks JR5539 Operating instructions

Bath Step

A single Bath Step has a height of 4” and is provided with an anti-slip surface. Each step is

stackable to form stairs or to increase the stepping height.

For Single Step:

 Ensure that the Bath Step is clean and dry, remove the protective film from the back of

the mat and place on top of the step and press firmly.

For Multiple Steps:

1. Use a knife or flat head screwdriver to carefully remove all (4) caps from the top of the

Bath Step. Please use caution. Keep the caps for future use.

2. Place the additional step directly on top of the other step. The feet underneath the top

step should align with the holes on the bottom step. Repeat for additional steps.

Note: If you stack several Bath Steps on top of each other, the anti-slip mat is only placed on

the highest step. In this case, please keep the extra mats so you can replace the top mat later

on (if it gets worn out or damaged).

To form a longer platform or a stair step:

 Locate the hook on one of the sides of the Bath Step and link it to the side opposite of the

hook of the other step. Ensure the steps are properly linked and laid flat before stepping.

Maximum user weight: 418 lbs

CAUTION: Always use extreme caution when getting in or out of the bathtub.

Made in China

12/09