Automate 7213A Owner's manual

Brand: Automate

Model: 7213A

Type: Owner's manual

MODEL

7213A

Compatible with the

following systems.

Automate 4214A

Replacement Transmitter

REPLACEMENT TRANSMITTER

Model 7213A 2-way 1-button Supercode Remote Control

The following Learn Routine can be used to program this replacement transmitter to the system. To enter the

Learn Routine, the programming button on the Control Center is used.

1. Turn the key to the ON position.

2. Press/release once and then press/hold the control

button on the system's Control Center. The status

LED begins flashing in a sequence of 1 flash and

the horn sounds once to confirm the system is

ready for pairing.

3. Release the control button.

4. Press /hold the remote button for 15 seonds. The

LED patterns change while holding. The horn

emits 1 sound to confirm learning.

5. Repeat for each remote to be learned (up to four).

6. Turn the ignition off or wait 60 seconds to exit

learning, the horn emits 2 sounds to confirm.

Remote Functions

System State

Press/Release

Press/Hold

for 3 sec.

ENGINE OFF START ENGINE CAR FINDER

ENGINE ON UNLOCK DOORS STOP ENGINE

FCC/ID Notice

This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may

not cause harmful interference, and (2) This device must accept any interference received, including interference

that may cause undesired operation.

CAUTION! Changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate this device.

MADE IN TAIWAN

P/N 7213A 01/19

560-10085 (R1.0)

WARNING:

This product can expose you to chemicals including DEHP, which is known to the State of Califotrnia to cause cancer

and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

Automate 7213A Owner's manual

Automate 7213A Owner's manual

Automate 7213A Owner's manual

Related papers

Other documents