Star Water Systems 2STHAL Operating instructions

Brand: Star Water Systems

Model: 2STHAL

Type: Operating instructions

Star Water Systems 2STHAL is a submersible utility pump intended to pump water or water-like liquids at temperatures up to 104° F. The device can run continuously whether partly or fully submerged, making it suitable for various applications, such as draining water from flooded basements, construction sites, or pools. It features an automatic thermal overload protector device, ensuring continuous operation without overheating. The pump comes with a 3/4" garden hose adapter, but can also be used with 1" or 1-1/4" NPT fittings by removing the adapter.

PREINSTALLATION CHECKLIST - ALL INSTALLATIONS

1. Check to be sure your power source is capable of handling the

voltage requirements of the motor, as indicated on the pump

name plate.

2. These pumps are not designed or intended to be used to handle

sewage or efuent.

3. This pump has been evaluated for use with WATER only.

4. Maximum continuous operating water temperature for standard

model pumps must not exceed 104°F (40°C).

Note: Pumps with the "CSA" mark are tested to CSA Standard

C22.2 No. 108.

REFER TO WARRANTY ON PAGE 2.

PERFORMANCE

Your pump is designed to effectively pump clear all storm and drain

waters. Although it will usually pass small particles suspended in

water, grass, heavy mud, sand or pea gravel can clog the pump

and reduce pump performance. This can usually be cleaned out by

backushing with a garden hose through the discharge. The normal

performance that can be expected is as follows:

GALLONS PER MINUTE AT

DISCHARGE HEIGHT ABOVE

PUMPING LEVEL

SHUT-OFF

HEAD

5 Ft. 10 Ft. 15 Ft.

1/6 15 11 6 19 Ft.

1/4 30 22 12 20 Ft.

FW0697

0611

Supersedes

0810

DO NOT USE FOR PUMPING OILS, GASOLINE OR ANY PETROLEUM BY-PRODUCTS.

Notice to Installer: Instructions must remain with installation.

Product information presented

here reﬂects conditions at time

of publication. Consult factory

regarding discrepancies or

inconsistencies.

1. Inspect your pump. Occasionally, products are damaged during shipment. If the unit is damaged, contact your dealer before

using. Do Not remove the test plug in the cover.

2. Carefully read the literature provided to familiarize yourself with specic details regarding installation and use. These materials

should be retained for future reference.

1. Make sure there is a properly installed ground fault circuit

interrupter (GFCI) protected circuit available. All pumps are

furnished with provisions for proper grounding to help protect you

against the possibility of electrical shock.

2. Make certain that the ground fault receptacle is within the reach

of the pump’s power supply cord DO NOT USE AN EXTENSION

CORD. Extension cords that are too long or too light do not deliver

sufcient voltage to the pump motor. But, more important, they

could present a safety hazard if the insulation were to become

damaged or the connection ends were to fall into the sump and

become wet.

3. Make sure the pump electrical supply circuit is equipped with fuses

or circuit breakers of proper capacity. A separate branch circuit is

recommended, sized according the National Electrical Code for the

current shown on the pump name plate.

4. TESTING FOR GROUND. As a safety measure, each electrical

outlet should be checked for ground using an Underwriters

Laboratory Listed circuit analyzer which will indicate if the power,

neutral and ground wires are correctly connected to your outlet. If

they are not, call a qualied licensed electrician.

5. Installation and checking of electrical circuits and hardware should

only be performed by a qualied licensed electrician.

6. FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP

FROM ITS POWER SOURCE BEFORE HANDLING.

7. These pumps are supplied with a 3-prong grounded plug to help

protect you against the possibility of electrical shock. DO NOT

UNDER ANY CIRCUMSTANCES REMOVE THE GROUND

PIN. The 3-prong plug must be inserted in a mating 3-prong

fault interrupter receptacle. If the installation does not have such

a receptacle, it must be changed to the proper type, wired, and

grounded in accordance with the National Electrical Code and all

applicable local codes and ordinances.

8. Risk of electric shock. This pump has not been investigated for use

in swimming pool areas.

9. According to the state of California (Prop 65), this product contains

chemicals known to the state of California to cause cancer and

birth defects or other reproductive harm.

SEE BELOW FOR LIST OF CAUTIONS

SEE BELOW FOR LIST OF WARNINGS

INSTALLATION INSTRUCTIONS

MAIL TO: 95 North Oak Street • Kendallville, IN 46755

(260) 347-1600 • 1 (800) 345-9422 • FAX (260) 347-0909

Quality Products Since 1866!

1/6 HP 115V @ 1.5 Amps UTHAL 433039 UTFAL

1/4 HP 115V @ 2.5 Amps 2STHAL 473685 2STFAL

115V @1.5 Amps UTFAL20

115V @2.5 Amps 2STFAL20

MODELS:

138011

NOTE: Ratings based on 1-1/4" pipe with friction loss neglected.

Using 3/4" garden hose adapter, performance will be reduced

approximately 15%. This pump does not deliver enough pressure to

operate lawn sprinklers properly.

OPERATION

1. Set pump on hard surface in water before starting.

2. Use the included garden hose adapater for 3/4" discharge line

or disconnect the adapter to use a 1" discharge for 1/6 HP or a

1-1/4" discharge for 1/4 HP.

3. Plug power cord into properly grounded 115 volt AC power

outlet. (See recommended grounding methods on front page).

Will operate continuously whether partly or fully submerged.

Submersible utility pumps are intended to pump clean or dirty

water or water-like liquids at temperatures up to 104˚ F.

4. The pump is supplied with a 3/4" garden hose adpater. For use

with plastic pipe, remove the adapter and install the desired

1" or 1-1/4" NPT tting. DO NOT OVERTIGHTEN THE HOSE

OR PLASTIC ADAPTER FITTING. Finger tight plus 1/2 turn is

sufcient.

NOTE: These pumps are manufactured with an air vent hole

near the base of the pump to prevent the pump from air-locking.

Air-locking will prevent the pump from pumping water. A stream

of water will be visible from this hole while the pump is running

and pumping water. The hole should be checked and cleaned

as needed.

Do not set pump directly on sand, dirt or mud.

Sand or mud-choked pumps can be back-

ushed clean.

Do not handle or carry the pump by the power

cord. Use the handle.

Extended usage of the pump in a partially

submerged or non-submerged situation may

cause the pump to overheat due to lack of heat dissipation from

the water. If this occurs, the pump will shut itself off until the motor

cools to its normal temperature. Repeated overheating may cause

damage to the pump.

MAINTENANCE

1. The motor housing of the pump is completely sealed and requires

no service. Disassembly of the motor housing or alteration of the

power cord voids all warranty.

2. The motor is a continuous duty type with an automatic thermal

overload protector device.

3. The pump can run against a partially restricted discharge.

4. If the pump becomes clogged, remove the screen and clean out

the area.

5. If necessary, remove the eight (8) screws holding the volute base

to the motor housing and clean the volute.

REPAIR PARTS

Repair Parts Listing

Description

Part Number

1/6 HP Model 1/4 HP Model

Impeller 120334 020328

Adapter 020348 022467

Coupling N/A 020331

Base 021338 020329

Screen 139492 139492

Mechanical Float

Switch

KH30* -

*Optional

This product is warranted for one year from the date of purchase or two years from

the date of manufacture, whichever occurs first. Subject to the conditions hereinafter

set forth, the manufacturer will repair or replace to the original consumer, any portion

of the product which proves defective due to defective materials or workmanship. To

obtain warranty service, contact the dealer from whom the product was purchased.

The manufacturer retains the sole right and option to determine whether to repair or

replace defective equipment, parts or components. Damage due to conditions beyond

the control of the manufacturer is not covered by this warranty.

THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions resulting from

failure to properly install, operate or maintain the unit in accordance with printed

instructions provided; (b) to failures resulting from abuse, accident or negligence or

use of inappropriate chemicals or additives in the water; (c) to normal maintenance

services and the parts used in connection with such service; (d) to units which are not

installed in accordance with normal applicable local codes, ordinances and good trade

practices; and (e) the unit is used for purposes other than for what it was designed and

manufactured.

RETURN OF WARRANTED COMPONENTS: Any item to be repaired or replaced

under this warranty must be returned to the manufacturer at Kendallville, Indiana or

such other place as the manufacturer may designate, freight prepaid.

LIMITED WARRANTY

THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER EXPRESS

WARRANTIES, AND MAY NOT BE EXTENDED OR MODIFIED BY ANYONE. ANY

IMPLIED WARRANTIES SHALL BE LIMITED TO THE PERIOD OF THE LIMITED

WARRANTY AND THEREAFTER ALL SUCH IMPLIED WARRANTIES ARE

DISCLAIMED AND EXCLUDED. THE MANUFACTURER SHALL NOT, UNDER

ANY CIRCUMSTANCES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR

SPECIAL DAMAGES, SUCH AS, BUT NOT LIMITED TO DAMAGE TO, OR LOSS

OF, OTHER PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE

, OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY TYPE OR

NATURE. THE LIABILITY OF THE MANUFACTURER SHALL NOT EXCEED THE

PRICE OF THE PRODUCT UPON WHICH SUCH LIABILITY IS BASED.

This warranty gives you specific legal rights, and you may have other rights which

vary from state to state. Some states do not allow limitations on duration of implied

warranties or exclusion of incidental or consequential damages, so the above limitations

may not apply to you.

WARRANTY VALID IN CANADA AND MEXICO.

Page is loading ...

Star Water Systems 2STHAL Operating instructions

Brand: Star Water Systems

Model: 2STHAL

Type: Operating instructions

Download PDF

report

in other languages

français: Star Water Systems 2STHAL Mode d'emploi
español: Star Water Systems 2STHAL Instrucciones de operación

Star Water Systems 2STHAL Operating instructions

Star Water Systems 2STHAL Operating instructions

in other languages

Related papers

Other documents