PAC BKGMK352 is a mounting kit that lets you install a double DIN aftermarket radio into select GM vehicles. It's compatible with 2004-2012 Chevy Malibu/Malibu Maxx, 2005-2010 Chevy Cobalt, 2006-2011 Chevy HHR, 2005-2006 Chevy Equinox, 2005-2009 Pontiac G6, 2007-2009 Saturn Aura, 2007-2008 Saturn Ion, 2006-2007 Saturn Vue, 2006-2010 Pontiac Solstice, and 2007-2009 Saturn Sky.
The kit includes left and right mounting brackets, screws, and a back strap (optional) to support the rear of the radio component. It's easy
PAC BKGMK352 is a mounting kit that lets you install a double DIN aftermarket radio into select GM vehicles. It's compatible with 2004-2012 Chevy Malibu/Malibu Maxx, 2005-2010 Chevy Cobalt, 2006-2011 Chevy HHR, 2005-2006 Chevy Equinox, 2005-2009 Pontiac G6, 2007-2009 Saturn Aura, 2007-2008 Saturn Ion, 2006-2007 Saturn Vue, 2006-2010 Pontiac Solstice, and 2007-2009 Saturn Sky.
The kit includes left and right mounting brackets, screws, and a back strap (optional) to support the rear of the radio component. It's easy
CUSTOMER HELP LINE
USA 800-323-4329 • Canada 800-245-8777
GMK352 Mounting Kit
VEHICLE APPLICATIONS
iGMK352
Chevy
2005-10 COBALT
2005-06 EQUINOX
2006-11 HHR
2004-12 MALIBU
2004-07 MALIBU MAXX
Pontiac
2007-10 G5
2005-09 G6
2006-10 SOLSTICE
2006 TORRENT
Saturn
2007-09 AURA
2006-07 ION
2007-09 SKY
2006-07 VUE
SAAB
2007-08 9-7X
©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 5/15 PRINT Ver. 5/15
WWW.AIUS.NET
2500 East Francis Street Ontario, CA 91761, U.S.A.
USA Sales (800) 336-6500
Canada Sales (888) 922-3006
For information about other American International automotive
accessories visit our website at:
http://www.aius.net
1. Carefully unclip the thin side trims from both the left and right side of the radio
dash trim bezel.
2. Remove the (2) 9/32 screws from below the driverʼs side under-dash panel.
3. Unclip and remove the side edge panel from the left side of the dash.
4. Remove the (2) 9/32 screws securing the left side of the driverʼs under-dash panel.
5. Unclip the wire harness from the side trim of the driverʼs side
under-dash panel.
6. Using a panel removal tool, carefully pry downward on the panel at the bottom of
the driverʼs side under-dash panel. (There are (3) panel clips).
7. Using a panel removal tool, unclip the top edge of the driverʼs side lower dash
panel and lower out of the way.
8. Lower the glove box door all the way down.
9. Remove the single 9/32 screw from the middle of the glove box door latch bar.
10. Remove the (4) 9/32 screws securing the glove box dash section to the sub-dash.
11. Carefully remove the side panel from the right side of the dash.
12. Repeat steps 4 and 5 above for the right side of the dash.
13. Unclip and lower the panel below the glove box and remove the single 9/32 screw
from the lower left side of the glove box panel, and remove glove box and panel.
14. Starting from the bottom of the radio/climate control trim bezel, pull bezel outward
to unfasten.
15. Disconnect the hazard harness from the radio/climate control bezel
and remove bezel.
16. Loosen the (2) 9/32 screws securing the climate controls.
17. Remove the (4) 9/32 screws securing the radio to the sub-dash.
18. Carefully pull radio upward and outward, disconnect the wire harness and antenna
lead and remove radio.
DASH DISASSEMBLY
2
004-2012 CHEVY MALIBU / MALIBU MAXX
1. Carefully pop trim above glove box with a panel removal tool. Remove trim at the top
left of dash bezel.
2. Remove dash panel with panel removal tool.
Note: Dash panel clips are very tight.
3. Disconnect wire harness behind dash panel
4. Remove (4) 9/32 screws and pull out radio. Unplug wire harness and antenna adapter.
DASH DISASSEMBLY
2005-2010 CHEVROLET COBALT
2 7
NOTES:
6 3
1. Carefully pry back and remove trim panel at the rear of the shifter console.
2. Remove the rubber mat from around the rear of the shift lever.
3. Carefully pry up the rear of the dash trim from around the shift lever and disconnect
the window harness at the back edge of the trim.
4. Carefully pry dash bezel forward, disconnect the hazard harness and lay the bezel
gently out of the way.
5. Remove the (4) 9/32 screws securing the factory radio to the sub-dash.
6. Carefully pull radio forward, disconnect the wire harness and antenna lead and
remove radio.
DASH DISASSEMBLY
2005-2006 CHEVROLET EQUINOX
2006 PONTIAC TORRENT
1. Starting from the top edge of the power window controls, gently pry back on the
window button trim, pull back to remove.
2. Remove the (2) 9/32 screws securing the upper top edge of the forward section of
the center console.
3. Starting from the rear of the forward console shifter trim, carefully pry upward on trim
to release trim, pull the console trim, disconnect the window harness and remove
console trim.
4. Starting from the bottom edge, carefully pull the Radio/Climate control trim bezel
forward, disconnect the harnesses attached to the rear of the trim bezel and climate
controls, and remove trim bezel.
5. Loosen the (4) 9/32 screws securing the climate control module about _ inch (it is not
necessary to remove the screws or module) and pull outward.
6. Remove the (4) 9/32 screws securing the factory radio to the sub-dash, pull radio
forward, disconnect the wire harnesses and antenna lead and remove radio.
DASH DISASSEMBLY
2
006-2011 CHEVROLET HHR
1. Remove side trim panels from both drivers and passenger side dash with a flat
blade screwdriver.
2. Remove (2) 9/32 screws on both drivers and passengers side dash.
3. Remove (3) 9/32 screws from under steering column panel. Remove and set aside.
4. Remove (9) 9/32 screws which hold entire glove box assembly in place. Lower glove
box and set aside.
5. Gently remove dash assembly from around radio, uncliping 1 plug located between
vents. Remove (4) 9/32 bolts securing radio in place.
6. Remove (2) 9/32 bolts securing heater control assembly in place. Slide heater control
assembly forward and remove factory radio.
DASH DISASSEMBLY
2005-2009 PONTIAC G6
NOTES:
Remove shaded tabs on
left and right sides for the:
Chevrolet
Cobalt
HHR
Pontiac
G5
Saturn
Aura
ION
Sky
VUE
4 5
Note: OEM amplifier located in rear passenger side trunk, underneath taillight
1. Remove the trim around the shift knob.
2. Remove panel with storage pocket, and unplug the power-outlet plug.
3. Remove the trim panel which goes across from the passenger side to the ignition
switch and underneath/around the radio/climate controls. Note: you will need to
unsnap the instrument cluster panel to allow trim panel to completely come out.
4. Remove the 6 (7mm) screws holding the radio and climate controls together.
5. Remove the radio and disconnect all plugs from the radio.
DASH DISASSEMBLY
2
007-2009 SATURN AURA
1. Remove the trim around the shift-knob.
2. Remove entire panel around the cup holders and shift-knob.
3. Disconnect the power-outlet plug from panel.
4. Starting at the bottom, underneath the climate controls, remove the dash panel
surrounding the climate controls and radio (panel includes above 2-vents and storage
pocket). Disconnect the hazards light switch and airbag light.
5. Remove 4 (7mm) screws holding the radio and disconnect the harnesses from
the radio.
DASH DISASSEMBLY
2007-2008 SATURN ION
1. Remove (by pulling upward) the entire panel (includes window switches) surrounding
the shift-knob.
2. Disconnect the window switch and power-outlet plug(s).
3. Remove 4 (7mm) screws from storage pocket/seat heaters.
4. Starting at the bottom, pull panel (containing climate controls) and slowly work your
way to the top. This part is all one piece from the bottom of the climate controls to the
top of the dash above the radio.
5. Disconnect the climate control, hazard and passenger airbag light plug(s).
DASH DISASSEMBLY
2006-2007 SATURN VUE
1. Carefully pry outward and remove the cover place from behind the center console
handle on the right side of the console.
2. Remove the (2) 10 mm bolts securing the handle.
3. Using a fine edge panel removal tool, carefully pry the entire dash trim bezel outward.
4. Disconnect all harnesses attached to the rear of the trim bezel.
5. Carefully lean the entire trim bezel towards the driver's side and rest out of the way.
6. Remove the (4) screws securing the factory radio to the sub-dash, pull the radio
forward, disconnect all harnesses and antenna lead and remove radio.
DASH DISASSEMBLY
2006-2010 PONTIAC SOLSTICE
2007-2009 SATURN SKY
IMB 352L
IMB 352R
Fig. B
1. Attach left and right mounting brackets to the kit as shown in Figure B.
2. Insert ISO mountable radio between ISO mount brackets and loosely attach to
sides of radio using screws provided with radio when possible or screws supplied
with kit.
3. Slide radio forward or backward for desired look and tighten screws.
4. Support the rear of the radio component(s) with back strap (not included) optional.
DOUBLE DIN MOUNT INSTALLATION INSTRUCTIONS
Remove
shaded
tabs on
left and
right sides
-
1
-
2
-
3
-
4
PAC GMK352 User manual
- Type
- User manual
- This manual is also suitable for
PAC BKGMK352 is a mounting kit that lets you install a double DIN aftermarket radio into select GM vehicles. It's compatible with 2004-2012 Chevy Malibu/Malibu Maxx, 2005-2010 Chevy Cobalt, 2006-2011 Chevy HHR, 2005-2006 Chevy Equinox, 2005-2009 Pontiac G6, 2007-2009 Saturn Aura, 2007-2008 Saturn Ion, 2006-2007 Saturn Vue, 2006-2010 Pontiac Solstice, and 2007-2009 Saturn Sky.
The kit includes left and right mounting brackets, screws, and a back strap (optional) to support the rear of the radio component. It's easy
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Metra Electronics 95-3302 User manual
-
American International NDK746 Owner's manual
-
Metra 95-3302 Specification
-
-
Metra 99-3302 Installation guide
-
Metra WM-GMK01 User manual
-
-
Metra 99-2001 User manual
-
Metra Electronics 952001 User manual
-
Voxx EXPNAV2 Installation guide
