Heath Zenith 6180 Series User manual

-

+

-

+

-

+

Type “D”

This package includes (Style of push button and chime may vary from illustration):

• Wirelesschime

• Wirelesspushbuttonwithbattery(Specicmodelsinclude2)

• Hardwarepack

This chime requires 3 “D” alkaline batteries (not included). In typical use,

alkalinebatterieswilllastuptothreeyears.

6180 Series, 6270 Series,

and 6280 Series

Decorative Wireless

Chime

Cover Mounting Tabs

Chime

Volume

Jumpers

Figure 1

WARNING: To prevent possible

SERIOUS INJURY or DEATH:

• NEVER allow small children near

batteries.

• If battery is swallowed, immediately

notifydoctor.

1. InstallalkalinetypeA2312voltpushbutton

battery(included). Remove back of case by

pushingintabonbottomwithasmallscrew-

driver(seeFigure1).Seediagraminsidepush

buttonforcorrectbatteryorientation.Note: If

batteries are preinstalled, remove orange

batterytab.

2. Install 3 alkaline “D” batteries. Make sure

batteriesareorientedproperly(seeFigure2).

3. Test range. Temporarily position chime and

pushbuttonwhereyouwantit mounted.

Press push button to verify chime and push

button work properly. If chime does not

sound, see Troubleshooting.

4. Adjust volume control. Adjust volume control

todesiredvolume(seeFigure2).

Figure 2

-2-

595-5506-12

12345

678

Jumpers

Chime Volume

SawtoothHanger

Figure 4

5. Mount push button. Use either screws ordouble

sidedtapetomountpushbutton.

• Screw Mounting:Tomountwithscrews,remove

backofcasebypushingintabonbottomwithasmall

screwdriver(seeFigure1).Note: Remove material in

screwholes(ifneeded)beforemountingwithscrews.

Attachbackofcasetodoorjamborwall(seeFigure

3).Snapfrontofpushbuttonon.

• Tape Mounting:Whenattachingpushbuttonusing

double sided tape, make sure the surface of the door

jamborwallisclean.

6. Mount chime.

Determinemountinglocation.

 Therearedifferentwaystomountthechimedepending

uponthemodelofchimepurchased.Determinewhich

modelyoupurchasedbelow.Mountthechimeaccording

totheinstructionsforyourchime.

ChimewithAttachedDecorativeCover:

1. Drill1/4"diameterpilotholeforwallanchor(provided)andinsertanchor.

2. Screw#8screw(provided)intoanchor.Leave1/16"gapbetweenscrewhead

andwall.

3. Placehangeroverscrewtomountchime(seeFigure4).

Figure 3

SawtoothHanger

Screw

-3-

595-5506-12

ChimewithSeparateDecorativeCover:

Thechimebasecanbemountedintwodifferentways.Thebasecanbemounted

usingthekeyholesorthethreemountingholes.Thebasemaybemountedhori-

zontallyorverticallydependinguponthespecicmodelpurchased.

KeyholeMounting:

• Usetemplateonbackcoverofmanualforscrewplacement.Note: Make

sureholesarelevelbeforedrilling.

• Drilltwo7/32"diameterpilotholesforwallanchorsandinsertanchors.

• Mountkeyholescrewstowallleavingabout1/8"(3mm)ofthescrewthreads

exposed(seeFigure5).

•

Usingkeyholesonbackofchimebase,hangbaseonscrews.

• Placechimecoverovertab(s)ontopofchimebase.

ScrewMounting:

• Removebatteriesfromchime.

• Placechimeagainstwallandverifythechimeislevel.

• Usechimeholesasatemplate(seeFigure6).Drillthree7/32"diameterpilot

holesforwallanchors(provided)andinsertanchors.

• Insert3screws(provided)throughholesinbackofchime.

• Verifychimeislevelandtightenscrewssecurely.

• Replacebatteries(seeFigure2).

• Placechimecoverovertab(s)ontopofchimebase.

Figure 5 - Back of Chime Figure 6 - Inside Chime

Keyhole Slots

(Horizontal Mounting)

Keyhole Slots

(Vertical Mounting)

Cover Hanging

Tabs

Keyhole

Screw(x2)

ScrewMounting

Holes

Note:Chimeshown

mountedvertically.

Note:Chimeshown

mountedhorizontally.

-4-

595-5506-12

1 2 3 4 5 6 7 8

Battery

C

h

i

m

e

V

o

l

u

m

e

1234 5678

Tune Settings

Yourwirelesschimehasdifferentselectabletunes:Ding (one note), Ding-Dong

(twonote),orWestminster(eightnote)(Availableonselectedchimes).The

factorysettingisfortheDing-Dongtune(orWestminster,whenavailable).This

tunecanbechangedbyfollowingtheinstructionsbelow.

• Ding (one note tune)

 InsidePushButton:Addajumpertolocation8.

• Ding-Dong(twonotetune)

 InsidePushButton:Removejumperfromlocation8.

 InsideChime:Removejumperfromlocation8.

• Westminster (Eight note tune) (Available on selected chimes)

 InsidePushButton:Removejumperfromlocation8.

 InsideChime:Addajumpertolocation8.

Note:Allmodelshavebothfrontandbackdoortunecapabilities.Werecommend

the back door use the Ding tune and the front door use the Ding-Dong tune

(or Westminstertune,availableonselectedchimes).Modelsthatincludetwo

pushbuttonswillcomefactorysetforfrontandbackdoors.Decalsontherear

ofthepushbuttonwillindicateitssetting.

Note: Some models might require the use of

tweezerstoremoveandreplacethejumpers.

Figure 7

Inside Push

Button

Tune Setting

Inside Chime

Tune Setting

(Not used on all

models)

-5-

595-5506-12

Troubleshooting

A. Chime does not sound:

• Makesurepushbuttonandchimecodesarethesame(seeFigure8).

• Checkorientationofpushbuttonandchimebatteries(Seediagraminside

pushbuttonandchimeforcorrectbatteryorientation.)

• Checkchargeofpushbuttonandchimebatteries,replaceifnecessary.

B.Chimesounds when notintended (false triggers):Chime is receiving

interferencefrom anotherwirelessdevice; change thecode setting (see

Code Settingbelow).

C.BatteriesseemOK,butthechimedoesnotworkwheninstalled:

• Donotmountchimeorpushbuttononmetalornearmetalstuds.This

reducesthetransmitterrange.Use1/4"to1/2"(6to13mm)woodshims

tomovechimeorpushbuttonoffmetalsurface.

• Concreteoorsmayreducerange.Movechimeawayfromoor.

• Trylocatingchimeclosertopushbutton.

D. Code Setting:

It is recommended to only change one code position at a time and then check

toseeifsystemisfunctioningproperly.

1. Openthecasesandlocatethejumpersonboththepushbuttonandchime

(seeFigure8).

2. Thepushbuttonandchimebothhaveeightdifferentjumperlocations.Jumper

positions1through7areusedforsettingthecode.

Continued

-6-

595-5506-12

3. Tochangethecode,either(Formodelswith2pushbuttons,changecode

settinginbothpushbuttonstomatchchime.):

• Addajumpertothesamelocationonboththepushbuttonandthechime

or...

• Removeajumperfromthesamelocationonboththepushbuttonandthe

chime or...

• Moveajumperonthepushbuttonfromonelocationtoanother.Movethe

correspondingjumperonthechimetomatchthenewlocationinthepush

button.

 Example: Movejumperatlocation“5”tolocation“4”onboththepush

buttonandthechime.

Note:Codepositions1through7mustbeexactlythesameforboththe

pushbuttonandchimeforthissystemtofunction.

Note:Unitwillcomefactorysetwithjumpersinlocations5,6,and7onthe

pushbuttonandonthechime(seeFigure8).

Therange of the wireless chime can vary with location,temperature,and

batterycondition.

Battery

C

h

i

m

e

V

o

l

u

m

e

12345678

* Code Settings 1-7

Must Match Both Push

Button and Chime

Inside Push

Button

Inside Chime

Note: Some models might require the use of

tweezerstoremoveandreplacethejumpers.

Figure 8

12345678

-7-

595-5506-12

Technical Service

Pleasecall1-800-858-8501(Englishspeakingonly)forassistance

beforereturningproducttostore.

Ifyouexperienceaproblem,followthisguide.Youmayalsowanttovisitour

Websiteat:www.hzsupport.com. If the problem persists, call* for assistance

at 1-800-858-8501,7:30AMto4:30PMCST(M-F).Youmayalsowrite*to:

HeathCo LLC

P.O.Box90045

BowlingGreen,KY42102-9045

ATTN: Technical Service

*IfcontactingTechnicalService,pleasehavethefollowinginformationavailable:

ModelNumber,DateofPurchase,andPlaceofPurchase.

NoServicePartsAvailableforthisProduct

Please keep your dated sales receipt, it is required for all warranty

requests.

RegulatoryInformation

ThisdevicecomplieswithPart15oftheFCCRulesandRSS-210ofIndustry

Canada.Operationissubjecttothefollowingtwoconditions:(1)thisdevicemay

not cause harmful interference, and (2) this device must accept any interference

received,includinginterferencethatmaycauseundesiredoperation.

Theuseriscautionedthatchangesormodicationsnotexpresslyapprovedby

the party responsible for regulatory compliance could void the user’s authority

tooperatetheequipment.

-8-

595-5506-12

HeathCoLLCreservestherighttodiscontinueandtochangespecications

atanytimewithoutnoticewithoutincurringanyobligationtoincorporatenew

featuresinpreviouslysoldproducts.

LIMITED WARRANTY

Thisis a“LimitedWarranty” whichgivesyouspecic legalrights.You

mayalso haveotherrightswhich varyfromstate tostateorprovince

toprovince.

Foraspeciedperioddependinguponmodel(seechartbelow)fromthe

date of purchase, any malfunction caused by factory defective parts or

workmanshipwillbecorrectedatnochargetoyou.

Not Covered - Repair service, adjustment and calibration due to misuse,

abuse or negligence, light bulbs, batteries, and other expendable items

arenotcoveredbythiswarranty.Unauthorizedserviceormodicationof

theproductorofanyfurnishedcomponentwillvoidthiswarrantyinits

entirety.Thiswarrantydoesnotincludereimbursementforinconvenience,

installation, setup time, loss of use, unauthorized service, or return ship-

pingcharges.

ThiswarrantycoversonlyHeathCoLLCassembledproductsandisnot

extended to other equipment and components that a customer uses in

conjunctionwithourproducts.

THISWARRANTYISEXPRESSLYINLIEUOFALLOTHERWARRAN-

TIES,EXPRESSORIMPLIED,INCLUDINGANYWARRANTY,REPRE-

SENTATIONORCONDITIONOFMERCHANTABILITYORTHATTHE

PRODUCTSAREFITFORANYPARTICULARPURPOSEORUSE,AND

SPECIFICALLYINLIEUOFALLSPECIAL,INDIRECT,INCIDENTAL,OR

CONSEQUENTIALDAMAGES.

REPAIRORREPLACEMENTSHALLBETHESOLEREMEDYOFTHE

CUSTOMERANDTHERE SHALL BE NO LIABILITY ONTHE PART

OFHEATHCOLLCFORANYSPECIAL,INDIRECT,INCIDENTAL,OR

CONSEQUENTIALDAMAGES,INCLUDINGBUTNOTLIMITEDTOANY

LOSSOFBUSINESSORPROFITS,WHETHERORNOTFORESEE-

ABLE.Somestatesorprovincesdonotallowtheexclusionorlimitationof

incidental or consequential damages, so the above limitation or exclusion

maynotapplytoyou.

Pleasekeepyourdatedsalesreceipt,itisrequiredforallwarranty

requests.

Model WarrantyPeriod

6270Series 1 Year

6180Series,6283,6284 5 Years

Page is loading ...

Heath Zenith 6180 Series, 6270 Series, 6280 Series User manual

Related papers

Other documents