2. OUTDOOR INDUSTRIES
  3. LED-TCH-DIM
LED-TCH-DIM

OUTDOOR INDUSTRIES LED-TCH-DIM User manual

  • Hello! I've read the Operating Instructions for the LED-TCH-DIM. This document describes a touch panel dimmer designed for LED lamps with features such as adjustable brightness, a high sensitivity touch control, and multiple brightness modes. I'm ready to answer your questions about this device.
  • What is the operating temperature range for this device?
    What is the supply voltage for this LED controller?
    How many brightness modes does the controller have?
1
OPERATING INSTRUCTIONS FOR LED-TCH-DIM
Web: www.outwater.com
Phone: 1-800-631-8375
SUMMARIZATION
The LED-TCH-DIM touch panel dimmer is our new high-end controller. The glass panel design is beautiful as well
as stylish. This dimmer boasts a high capacity touch control chip which increases the touch sensitivity and reduces
accidental inputs. Used to control LED lamps and lanterns.
TECHNICAL PARAMETERS
• Working Temperature: -20-60°C
• Supply Voltage: DC12~24
• Output: 1 channel
• Connecting Mode: Common anode
• External Dimension: L 86 x W 86 x H 37mm
• Packing Size: L 90 x W 90 x H 60mm
• Net Weight: 125g
• Gross Weight: 150g
• Static Power: < 1W
• Output Current: < 8A
• Output Power: 12V: < 96W | 24V: < 192W
2
External Dimension
Interface Specications
Controller Instructions
Touch panel has two buttons and a pulley. The keys function as follows:
Any state that can be opened or closed the controller outputs
Brightnessselectkey.Canchoosedierentbrightness,atotalofsevenchangemodes.
Pulleytouchbuttons,promisebrightnessselectkey,asmanyas128touchpoints.
The key has two functions:
1.Pulleybrightnessselectkey,namelythecontrolmodeforMkeymode(brightness),ifmust
realizethepulleyofbrightness,canpressthisbutton.
2.Thepulleybrightnessswitchbutton:from64canbestaticcolor(brightness)switch.
3
Installation
1. Openthetouchpanelasshown.Useascrewdrivertogentlyprythegaps.Takethepanelasshowningure:
theatcabletakendown.
2. Openthelockconnectionseat,taketheatcablewiringinthetypicalapplication.Referencetheabovediagram.
3. Install the switch base as shown in the illustrations. The connected line will touch installed on the wall in the cas-
sette controller. Screw in the screws to attach the dimmer to the wall.
4. Coverthetouchpanelaccordingtostepupgoodrowline,lockatcablelock,coverpanel.
Typical ApplicationMode Functions
Mode No. Dims
1 10%
2 20%
3 30%
4 40%
5 50%
6 60%
7 70%
8 80%
9 90%
10 100%
4
Notes:
1. Connecttheloadwirerst,followedbythepowerwire.TOENSURETHATASHORTCIRCUITCANNOT
OCCURCONNECTTHEWIRESBEFOREYOUTURNONTHEPOWER.
2. The power supply voltage range is DC 12~24. DONOTEXCEEDTHERECOMMENDEDVOLTAGERANGEAS
THISCANBURNOUTTHECONTROLLER.
/