2. Laser
  3. EPS-KWGLOW-GN
EPS-KWGLOW-GN

Laser EPS-KWGLOW-GN User manual

  • Hello! I'm a chat assistant and I've just reviewed the user manual for the Laser Earphones EPS-KWGLOW-GN. This document provides instructions on how to use the device, including its media and light controls, charging, and troubleshooting. I'm here to answer your questions about these earphones. Feel free to ask!
  • How do I turn on the light function?
    How do I turn off the light function?
    How do I charge the earphones?
    How long does it take to fully charge the battery?
    Do the earphones need battery to work?
User Manual
Light Up Earphones
EPS-KWGLOW-GN
SPK-ST40-972
Thank you
for your purchase!
Laser Corporation is 100% Australian owned &
operated. To get the most out of your product
please read the user manual carefully and keep
for future use.
For specific information relating to your product
such as Spare Parts, FAQs, Warranty claims, and
more, please scan the following QR code:
WHAT’S IN THE BOX
• Earphones
• Charging Cable
• 2 x Sets of Spare Earbuds
• User Manual
Earphone Driver Size: 10mm
Impedance: 32Ω
Sensitivity: 96dB +/- 3dB
Frequency Range: 20 – 20,000Hz
Cable Length: 102cm
Battery Capacity: 80mAh
Charging Input: 5V/1A (max)
SPECIFICATIONS
Charging Time: 30 minutes
PRODUCT DIAGRAM
3.5mm
Audio Jack
Microphone
Multifunction
Button
Charging
Port
MULTIFUNCTION BUTTON
MEDIA CONTROLS
• Play/Pause Tap during music playback.
Tap during incoming call.
Tap during call.
• Answer Call
• End Call
MULTIFUNCTION BUTTON
LIGHT CONTROLS
• Press and hold the multifunction button for
two seconds. The light flashes along the
cable to turn ON the light function.
When the volume reaches 70% or more
during music playback the light on the
cable will flash.
• Press and hold the multifunction button for
two seconds. The light flashes along the
cable 3 times to turn OFF the light function.
CHARGING
• Plug the included USB cable into a 5V/1A
charging source.
• The battery will take 30 minutes to
charge fully.
Note: The battery is only required for the
cable light function. No battery is
required to use the earphones.
• Unplug the earphones and plug back in.
• Try the earphones on another device.
• Check the 3.5mm port you are plugging
into is an audio out port.
My device is not detecting
the earphones.
TROUBLESHOOTING
www.laserco.com.au
Check us out at
www.youtube.com/lasercoau
Visit our website
/