3
ASSEMBLY STEPS
STEP 1
Place Desk Sleeve (A) onto the desktop at the desired location. Measure the space between
the underside of the desktop and the lower portion of the sleeve to determine the required
Spacers (S-A) and Washers (S-E) for mounting. Remove Desk Sleeve (A) from the desktop.
STEP 2
Begin by installing your keyboard
mount (not provided) to Desk Sleeve
(A). Depending on the mount being
installed, use M5x8mm Screws (S-C) or
M6x8mm Screws (S-D) to secure mount
to Desk Sleeve (A). Tighten with a Phillips
screwdriver.
STEP 3
Fit Desk Sleeve (A) with installed
keyboard mount to the desktop. Use
Desk Sleeve (A) and a pencil to mark
drilling locations. Drill 10mm (.4”) deep
pilot holes in the desktop for Curved
Desk Sleeve and the rear end of the
keyboard mount using a 3mm (1/8”) drill
bit.
STEP 4
Secure Desk Sleeve (A) and keyboard mount to the desk using M5x35mm Screws (S-B)
with M6 Spacers (S-A), and M5 Washers (S-E) determined in Step One. Tighten with a
Phillips screwdriver.
DESKTOP
A
A
S-C
S-D
S-A S-E
Note: the quanitity of Spacers & Washers needed is determined by the gap of space between desktop and bottom of
Sleeve. The use of one Spacer & Washer with each screw above is for visual aide ONLY.
A
A
S-B
