User’s manual – AREBOS Electric Kettle 3000W Retro
5
2.2 First use of the kettle
Please read these operating instructions carefully and keep them in a safe place for future reference.
Before using for the first time, boil and pour away the boiled water. Repeat once or more if a taste or
smell is noticed. Use only water without any additives or ingredients.
2.3 Use
1. Place the kettle on a flat surface.
2. Lift off the kettle lid. Then fill with cold water. The water level can be read off the water level
indicator at the side of the kettle. Do not overfill the kettle.
3. Put back the lid, make sure lid was fully inserted.
4. Place the kettle on the base unit.
2.4 Electrical connection
1. Check whether the mains voltage supply that you intend to use is same as the kettle. For
information on the voltage supply of the kettle, please see the rating label on the base.
2. Switch on the kettle using the On/Off switch. The control lamp lights up.
3. The kettle switched off automatically when the water has boiled. Now disconnect the kettle
from the mains power supply if on further use is required. Always ensure that the lid is
locked in closed position when pouring the water out. Beware of scalding!
3. Maintenance
3.1 Regular Cleaning
• Read the safety instructions in this manual before cleaning.
• Switch off, unplug, empty the kettle and allow to cool before cleaning.
• Open the lid, remove the filer, rinse the filter under warm water and brush off any impurities.
• The extensor if the kettle should be cleaned, if necessary, with a slightly damp cloth. Dot not
use harsh or abrasive cleaners!
• It is recommended that you regularly descale your kettle using a kettle descaler to increase
the life expectancy and reduce lime scale build up, in extreme hard areas we highly
recommend using filtered water in your kettle to increase the life expectancy and prevent
lime scale build up.
3.2 Descaling
1) Fill the kettle up to “max“ with a mixture of one part ordinary vinegar and two parts water.
Switch on and wait for the appliance to switch off automatically.
2) Let the mixture remain inside the kettle overnight.
3) Discard the mixture the next morning.
4) Fill the kettle with clean water up to “max“ mark and boil again.
5) Discard the boiled water to remove any remaining scale and vinegar.
6) Rinse the inside of the kettle with clean water.
• Notice: Descale the kettle regularly. With normal use: at least twice a year!