ZyXEL ONU5100-B22 User manual

Brand: ZyXEL

Model: ONU5100-B22

Category: Network media converters

Type: User manual

User’s Guide

ONU5100-B22

EPON ONU SFP Transceiver Module

Version 1.00

Edition 1, 8/2009

Overview

The ONU5100-B22 is an EPON transceiver module that

complies with the Small Form-factor Pluggable (SFP)

Transceiver MultiSource Agreement (MSA). Installing

the ONU5100-B22 in the SFP port on a switch lets the

SFP port act as an optical network unit (ONU) that

allows you to enjoy high-speed Internet access over

optical networks.

Internet

OLT

Switch

ONU

The ONU5100-B22 comes with one fiber port. No

configuration is required as all device configuration is

done remotely by the OLT (Optical Line Terminal).

Once you have connected the hardware, you are ready

to access the Internet.

Hardware Installation

You can install or remove the ONU5100-B22 while the

switch on which you want to install the ONU5100-B22

is operating.

To avoid possible eye injury, do not look into an

operating fiber-optic module's connectors.

Transceiver Installation

Use the following steps to install the ONU5100-B22 in

an SFP port.

1. Insert the ONU5100-B22 into an SFP port with the

exposed section of PCB board facing down.

2. Press the ONU5100-B22 firmly until it clicks into

place.

3. The switch with the SFP port automatically detects

the installed ONU5100-B22. Check the LEDs to

verify that it is functioning properly.

4. Use an SC-type, single-mode optical cable to

connect the ONU5100-B22’s PON port and an OLT

for Internet access.

Transceiver Removal

Use the following steps to remove the ONU5100-B22

from an SFP port.

1. Remove the fiber optic cable from the ONU5100-

B22.

2. Open the ONU5100-B22's latch (latch styles vary).

3. Pull the ONU5100-B22 out of the port.

Test Your Connection

After you have installed and connected the ONU5100-

B22 to an OLT, open a web browser on your computer

which is connected to the switch on which the

ONU5100-B22 is installed and go to any web site (for

example, www.zyxel.com) to test your Internet

connection.

ENGLISH

If you cannot connect to the Internet, make sure the

OLT has Internet access and the ONU5100-B22 is

registered with the OLT successfully.

If the ONU5100-B22 cannot register with the OLT,

• Check the connector on the optical cable and the PON

port. Make sure they are clean and dust-free. Use an

air duster to clean the connectors. Do NOT use a wet

cloth to clean the connectors.

• Check the optical cable. Make sure it is not broken. If

the cable is broken, contact your service provider to

have the cable/connector replaced.

Specifications

Specifications are accurate at the time of writing.

Feature Specification

Dimensions (mm) 75 (Wide) x 14 (Deep) x 12.4 (High)

Weight < 1 kg

Power Supply + 3.3V

Power Consumption < 2 W

Case Operation

Temperature

0 ºC ~ 70 ºC

Storage

Temperature

-40 ºC ~ 85 ºC

Safety Warnings

• Ground yourself (by properly using an anti-static wrist strap for

example) whenever working with the device's hardware or

connections.

• Do NOT use this product near water, for example, in a wet basement

or near a swimming pool.

• Do NOT expose your device to dampness, dust or corrosive liquids.

• Do NOT store things on the device.

• Do NOT install, use, or service this device during a thunderstorm.

There is a remote risk of electric shock from lightning.

• Connect ONLY suitable accessories to the device.

• Do NOT open the device or unit. Opening or removing covers can

expose you to dangerous high voltage points or other risks. ONLY

qualified service personnel should service or disassemble this

device. Please contact your vendor for further information.

• Make sure to connect the cables to the correct ports.

• Place connecting cables carefully so that no one will step on them or

stumble over them.

• Always disconnect all cables from this device before servicing or

disassembling.

Operation Humidity 0% ~ 85% (non-condensing)

Storage Humidity 0% ~ 95% (non-condensing)

PON Interface One PON port (single fiber link)

Compliant with IEEE 802.3ah

PX-20

SC optical connectors with shutters

Transmission distance: 20 km

Wavelength: 1310 nm upstream and

1490 nm downstream

Full duplex

Feature Specification

• Use ONLY an appropriate power adaptor or cord for your device.

• Do not use the device outside, and make sure all the connections

are indoors. There is a remote risk of electric shock from lightning.

• Make sure that the cable system is grounded so as to provide some

protection against voltage surges.

Your product is marked with this symbol, which is known

as the WEEE mark. WEEE stands for Waste Electronics

and Electrical Equipment. It means that used electrical

and electronic products should not be mixed with

general waste. Used electrical and electronic equipment

should be treated separately.

ZyXEL ONU5100-B22 User manual

Brand: ZyXEL

Model: ONU5100-B22

Category: Network media converters

Type: User manual

Download PDF

report

ZyXEL ONU5100-B22 User manual

ZyXEL ONU5100-B22 User manual

Related papers

Other documents