Gimoto RR V-Race Hybrid Technology User manual

Brand: Gimoto

Model: RR V-Race Hybrid Technology

Type: User manual

SYSTEM COMPONENTS

PARTS AND CONNECTIONS

THE VIRTUAL CABLE SYSTEM CONSISTS OF 3 DEVICES

THE CPU.

The brain of the system

THE ANTENNA ON THE VEST.

Called “VEST TAG”

THE ANTENNA ON THE BIKE.

Called “ANCHOR”

Anchoring to give exactly the concept of VIRTUAL CABLE ﬁxing

PARTS & CONNECTIONS

VEST CONNECTOR

Connect CPU to TAG

If not inserted the system cannot

work properly (CPU “Blinks” Purple)

ACTUATOR CONNECTOR

Connect actuator, if not connected

system cannot inﬂate the vest

PARTS & CONNECTIONS

DISCONNECT WHEN

REST FOR LONG TIME

Disconnect if not going to use the vest

for long time, it may drain the battery

TURN CPU OFF

BEFORE CONNECT/DISCONNECT

TAG may be damaged if CPU is on, then

the system cannot operate properly

(CPU “Blinks” Purple)

V-RACE RR CPU

CPU LED

CPU SWITCH

(ON IS RIGHT SIDE)

CHARGER PORT

V-RACE RR CPU

CPU needs to be charged at

least 6/8 hours before use,

using the USB charger sup-

plied in the box, and needs to

be charged each time cpu led

turns RED

Li-Ion accumulator requires

3 cycles to reach maximum

level of power

V-RACE RR BIKE ANCHOR

Anchor needs to be charged at leat 6h before use

using the USB charger supplied in the box, then

charge will last 24/30h.

Li-Ion accumulator requires 3 cycles to reach maxi-

mum level of power.

The ANCHOR system does not have a switch on/off

button. Once loaded, the system remains in charge

for 25/30 hours maximum.

ATTENTION: the system LEDs remain lit for the

entire charging time.

It is suggested to RECHARGE the system just before

the actual use OR to connect it permanently to the

motorcycle battery, under lock and key.

DO NOT USE THE SYSTEM

IF ANCHOR LEDS ARE OFF

V-RACE RR BIKE ANCHOR

POSITION

Anchor best positioning

At back of rider, in sight.

Inside tail installation allowed,

please check distance via App

to check anchor is seen in

action range (<1m)

V-RACE RR BIKE ANCHOR

DETECTION

Vest detect automatically all

anchors in range (up to 6 MT)

but it “choose” the nearest one

MOTORBIKE A

nearest anchor

farest anchor

MOTORBIKE B

V-RACE RR BIKE ANCHOR

ANCHOR BINDING

Vest automatically bind the anchor as soon

as bike starts.

So there’s no need to do any manual bin-

ding, neither changing anchor. The rider

can switch on another bike with a different

anchor and the CPU read it automatically.

The SYSTEM is ARMED , is ready to inﬂate

the AIRBAG, when the BIKE reaches the

minimum speed levels.

These minimum SPEED LEVELS ( street or

racetrack mode ) are chosen through the

VraceRR APP in the setting page.

V-RACE RR CPU - LED DIAGNOSTIC

STARTUP CYCLE (WHEN TURNED ON)

CHECK CPU CONNECTOR

SYSTEM NOT WORKING

PROPERLY

INITIALIZAZION STARTED (SYSTEM CHECK)

(SOLID YELLOW)

CHECK ENDS

STREET MODE

(FLASHING LIGHT BLUE)

RACETRACK MODE

(FLASHING WHITE)

SYSTEM OK

(FLASHING YELLOW)

NO TAG DETECTED

(FLASHING PURPLE)

DO NOT USE THE SYSTEM

IF LED TURN RED

V-RACE RR CPU - LED DIAGNOSTIC

OTHER LED MESSAGES

BATTERY NEED TO BE CHARCED

(SOLID RED)

ANCHOR DETECTED

(FLASHING ICE BLUE)

SYSTEM ACTIVATED

(SOLID PURPLE)

GPS SIGNAL LOCKED

(FLASHING GREEN)

SYSTEM ARMED

(FLASHING BLUE)

DO NOT USE THE SYSTEM

IF LED TURN RED

V-RACE RR CPU - APP

The V-RACE RR APP

is just an “Instant Diagnostic” for:

Battery Level of the CPU

Selection of the RIDING MODE

(STREET or RACETRACK mode)

RESET the CPU after an inﬂation.

App is used only for a “Instant Diagnostic” of

the CPU. The pairing must be reconnected each

time you need another “Instant Diagnostic”

THE SYSTEM WORKS WITHOUT THE APP. WHEN

THE CPU AND THE ANCHOR ARE SWITCHED ON,

THE SYSTEM WORKS AUTOMATICALLY

V-RACE RR CPU - APP PAIRING

CPU SERIAL AND PAIRING PASSWORD

Procedure is slightly different depending on your device

OS (Android or Apple iOS) and version of OS

Some devices using proprietary implementation of Bluetooth

may not be compatible. You can ﬁnd the CPU in the Bluetooth

panel on your mobile.

Turn on Bluetooth for

pairing the airbag CPU

and seach the device

VRACERR******

INSERT PIN CODE

VRACE RR

HW: R04.00

SN: 00328

PIN: 123456

V-RACE RR CPU - APP PAIRING

COMMON ISSUES

On Android devices using BLE requires

GPS position ON

On Android 10, the application itself

needs to be authorized

On some Android devices, pairing is a

bit tricky with paring

authorization request hidden in notiﬁ-

cation area

V-RACE RR CPU - APP PAIRING

COMMON ISSUES

Only one device per time can be paired and

connected, once connected the cpu may not be

seen from other smartphones

Once set desired mode (Track or Street) the

app is totally optional, the system will work

without any connection to a smartphone

Be a bit patient: connection requires some se-

conds, and entering connection menu the app

will try to connect last connected CPU automa-

tically. You can still connect any CPU in range

via Connection menu dropdown list

HELP LINKS

TUTORIAL AIRBAG STRETCH KIT

ELECTRONIC RECHARGE MECHANIC RECHARGE

ELECTRONIC MANUAL MECHANIC MANUAL

LED DIAGNOSTIC CATALOGUE

Gimoto RR V-Race Hybrid Technology User manual

Brand: Gimoto

Model: RR V-Race Hybrid Technology

Type: User manual

Download PDF

report

Gimoto RR V-Race Hybrid Technology User manual

Gimoto RR V-Race Hybrid Technology User manual

Other documents