2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Dometic
  6. MPD Draft Shield

Dometic MPD Draft Shield Installation guide

  • Hello! I've reviewed the installation instructions for the Dometic Draft Shield MPD 38143. This document outlines the steps required to properly install the new draft shield assembly, including stud installation, tightening the wing nut and positioning of the bezel. I’m ready to answer any questions you may have about the installation process.
  • What is the first step in the installation process?
    Where should the stud be inserted?
    How should the wing nut be tightened?
    Where should the bezel assembly be positioned?
INSTALLATION PROCEDURE
1. Remove screws and remove burner
assembly to install stud. (If cover is
not equipped with one already.)
2. Insert stud from back side of cover.
3. Tighten wing nut on stud until stud is
pulled snug into hole.
4. Install new draft shield assembly with
bezel assembly tight against back of
door screen when the door is
installed. Verify position of bezel
assembly before tightening wing nut
to hold it in place.
DRAFT SHIELD
INSTALLATION
Revision C, 9/18
4
2
1
3
LITERATURE NUMBER MPD 38143
For complete furnace
instructions, refer to the
manual provided with unit.
INSTALLATION PROCEDURE
1. Remove screws and remove burner
assembly to install stud. (If cover is
not equipped with one already.)
2. Insert stud from back side of cover.
3. Tighten wing nut on stud until stud is
pulled snug into hole.
4. Install new draft shield assembly with
bezel assembly tight against back of
door screen when the door is
installed. Verify position of bezel
assembly before tightening wing nut
to hold it in place.
DRAFT SHIELD
INSTALLATION
Revision C, 9/18
4
2
1
3
LITERATURE NUMBER MPD 38143
For complete furnace
instructions, refer to the
manual provided with unit.
INSTALLATION PROCEDURE
1. Remove screws and remove burner
assembly to install stud. (If cover is
not equipped with one already.)
2. Insert stud from back side of cover.
3. Tighten wing nut on stud until stud is
pulled snug into hole.
4. Install new draft shield assembly with
bezel assembly tight against back of
door screen when the door is
installed. Verify position of bezel
assembly before tightening wing nut
to hold it in place.
DRAFT SHIELD
INSTALLATION
Revision C, 9/18
4
2
1
3
LITERATURE NUMBER MPD 38143
For complete furnace
instructions, refer to the
manual provided with unit.
INSTALLATION PROCEDURE
1. Remove screws and remove burner
assembly to install stud. (If cover is
not equipped with one already.)
2. Insert stud from back side of cover.
3. Tighten wing nut on stud until stud is
pulled snug into hole.
4. Install new draft shield assembly with
bezel assembly tight against back of
door screen when the door is
installed. Verify position of bezel
assembly before tightening wing nut
to hold it in place.
DRAFT SHIELD
INSTALLATION
Revision C, 9/18
4
2
1
3
LITERATURE NUMBER MPD 38143
For complete furnace
instructions, refer to the
manual provided with unit.
DOMETIC CORPORATION
1120 North Main Street, Elkhart, IN 46514
Please Visit: WWW.DOMETIC.COM
DOMETIC CORPORATION
1120 North Main Street, Elkhart, IN 46514
Please Visit: WWW.DOMETIC.COM
DOMETIC CORPORATION
1120 North Main Street, Elkhart, IN 46514
Please Visit: WWW.DOMETIC.COM
DOMETIC CORPORATION
1120 North Main Street, Elkhart, IN 46514
Please Visit: WWW.DOMETIC.COM
/