PRODUCT SUPPORT | 800.927.2120 | WATERWORKS.COM PAGE 1 OF 1 | UPDATED ON 3.25.2022
STYLE No. LDRH15
Ludlow Volta Wall Mounted Robe
Hook
FINISHED WALL
HOOK *
* DRY-FIT AND MARK LOCATION
MOUNTING
PLATE
HOOK
SCREW
SCREW
MOUNTING
PLATE
MOUNTING
PLATE
HOOK
SCREW
SCREW
MOUNTING
PLATE
SCREW
MOUNTING
PLATE
ANCHOR
[6mm OD]
MOUNTING
PLATE
SCREW
[PRE-DRILLED
HOLES] [MOUNTING HOLES
MUST BE ORIENTED
VERTICALLY]
HOLES]
PLATE
SCREW
[3mm HEX]
SET SCREW
[1.5mm HEX]
ESCUTCHEON
[INTERNAL
O-RING]
ESCUTCHEON
[INTERNAL O-RING]
SET SCREW
[1.5mm HEX]
INSTALLATION GUIDELINES
4. Slide the ESCUTCHEON down the HOOK until it
contacts the finished wall then securely tighten the
SET SCREW.
Insert the HOOK and SCREW into the MOUNTING
PLATE then thread and securely tighten the
SCREW into the HOOK.
3. Using the previous marks as a reference, install
the MOUNTING PLATES using the SCREWS and
ANCHORS provided.
NOTE: Verify the MOUNTING PLATE is in the
proper orientation.
2. Loosen, but do NOT remove, the SET SCREW
on the bottom of the ESCUTCHEON and slide
the ESCUTCHEON up the ARM to expose the
MOUNTING PLATE then unthread the SCREW to
remove the PLATE.
1. Dry-fit the ROBE HOOK to the finished wall and
mark the ideal location.
IMPORTANT:
¾To ensure this product is installed properly,
you must read and follow these guidelines.
¾The owner/user of this product must keep
this information for further reference.
¾This product must be installed by a
professional licensed contractor.
¾Inspect this product to ensure you have all
the parts required for proper installation.
¾If further assistance is required, please
contact Product Support at 1-800-927-2120
Monday through Friday, 8am – 6pm EST.
¾Refer to the separate Service Parts
Documents for available replacement parts.