ENGLISH
LEGLIFTER
4
Fing instrucons (Proling Beds)
The exible construcon of the deated Leglier
makes it ideal for use with most types of proling bed.
However, please carefully follow these guidelines to
avoid any conict with moving secons of the bed.
• Remove the maress from the bed.
• Raise and lower the backrest and legrest secons
of the bed to idenfy strap posions which best
avoid chang/fouling of the straps.
• On the opposite side of the bed to where the
Leglier is to be ed, secure the loop end
of each strap to the inner frame as indicated
(A g.4). NOTE: Wrap the strap around the
frame several mes so as to shorten the strap
length, allowing the adjuster buckle to lie near
the centre line of the bed.
WARNING: When ng to a bed with a Low/High
funcon, ensure that the straps are aached to the
frame which moves up and down.
• Hook the two straps onto the ap of the Leglier as indicated in (B g.4) and pull on the strap at the
adjuster buckle to draw the ‘Vee’ of the deated Leglier inwards over the bed frame and under the
maress by about 1 to 2 ngers width (C g.5).
• Raise and lower the backrest and legrest secons of the bed, checking to ensure that the straps do not
interfere with the bed’s funcons.
• Ret the maress.
• Connect the Leglier to the Airo 12 compressor and with the backrest and legrest secons of the bed
in the horizontal posion, test that the Leglier inates to fully vercal against the maress. Tighten the
straps further if necessary. Upon nal adjustment, the edge of the ap seles to sit on the frame (under
the maress) by about 1 to 2 ngers width.
NOTE: Normally, the Leglier should be operated with all bed secons in the horizontal posion. If necessary,
the backrest can be raised up to 45° to assist upper body stability while the legs are raised.
WARNINGS:
• Do not operate the Leglier when the bed’s legrest is raised.
• Do not raise the bed’s legrest when the Leglier is inated.
• Always deate the Leglier aer the legs have been safely posioned on the bed.
NOTE: Where ed, any integral cotside on the transfer side of the bed must be removed to permit eecve
ng and operaon of the leglier.
A
B
CNOTE: If the bed secons are of
metal grid construcon, ensure the
strap hook has its open side facing
upwards, to avoid fouling the grid.
4
5