2. Hyco
  3. Flow Through Valve Kit

Hyco Flow Through Valve Kit Installation guide

  • I have analyzed the provided Product Installation Guide for the Flow Through Valve Kit. It details how to assemble the valve kit with the vessel, t-piece, and flow through valve, especially noting the importance of proper orientation and sealing. I am ready to answer your questions about the installation process and any other related details.
  • What is the correct orientation of the water diverter paddle?
    What is required to seal the threads of the vessel and flow through valve?
    Where can I find instructions for full installation including the inlet group?
Product Installation Guide
Flow Through Valve Kit with
Inlet Group for Powerow
v22.11.1
Assemble the vessel, t - piece and ow
through valve as shown in gure 1.
Screw the ow through valve as far into the
t - piece as it will go and then turn back if
necessary to achieve the orientation shown.
PTFE tape or similar will be required to seal
on the threads of both the vessel and the
ow through valve.
Orientation is important, the ow through
valve water diverter paddle should be at a
90° angle to the tube as shown in gure 2.
For full installation including inlet group see
gure 3.
gure 2gure 1
gure 3
/