GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT DISTRIBUTION HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500 350
4,000
NISSAN ROGUE S & SL, 2WD & AWD
10/19/2010
13185
90
31
45
HITCH WEIGHT: LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
78277
EXCLUDING KROM EDITION
Parts List DESCRIPTION
PART NUMBER
QTY
ITEM HEX BOLTM12-1.25 x 35mm61 CONICAL TOOTHED WASHER1/2"62
2
1
1) Remove tow hook from the passenger side frame rail (5 bolts) and return to customer.
2) Remove small screw from heat shield on the passenger side frame rail and return to customer.
3) Lower exhaust for ease of installation.
4) Raise hitch into position and secure with hex bolts and conical washers as shown in the diagram above.
5) Torque all 12mm fasteners to 65 LB-FT.
6) Re-install exhaust removed in step 3.
- REMOVE TIE DOWN
- LOWER EXHAUST
- NO DRILLING
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
EXISTING WELDNUTS
(BOTH FRAME RAILS)
TOOLS REQUIRED
3/8" DRIVE RACHET
3/8" DRIVE 8" EXTENTION
3/8" DRIVE TORQUE WRENCH
8mm - 3/8" DRIVE SOCKET
18mm - 3/8" DRIVE SOCKET
19mm - 3/8" DRIVE SOCKET
/