Let's Go Aero H01465-H01496 Owner's manual

BigBoss HOODie™

Accessory Cover For BigBoss Model Racks

Part No. H01496

For More Information & Accessories,

Visit our Website - www.LetsGoAero.com

BBHManual-010817

ASSEMBLY AND OPERATION

Unfold your BigBoss HOODie and drape over top of your BigBoss Carrier and any stored cargo. Fit the

thick Waist-Band of the HOODie snuggly over the corners of the carrier. Tighten and connect the adjustable

Release Buckle located underneath the velcro storm aps until taut.

Pull the long Support Straps around the underside of the carrier and back to meet at the top. Connect the

Release Buckle and pull tight to secure your HOODie and cargo to the carrier.

Unfold the included DragNet and drape over top the secured HOODie. Fasten all Molded Clips by securing

and evenly spacing them to anchor points located on the underside of the carrier.

PARTS LIST

Qty Description

1 HOODie Cover

1 DragNet Cargo Netting With Clips

HOODie & DragNet devices are a weather-

resistant (not water-proof) cargo protectant

system, and not a cargo restraint.

Be sure to remove your DragNet and

completely loosen and disconnect all

HOODie Release Buckles rst before

removing the HOODie off your cargo carrier

to avoid damage to your product.

WARNING WARNING

Always check that HOODie, DragNet & stored cargo are fully secured to the carrier before transit

to avoid loss or damage to your product & cargo. Multiple tie-down and strap positions are located

along the BigBoss Cargo Carrier for supplemental ratchet and tie-down restraints when necessary.

WARNING

Warranty Statement:

HOODie Cover and DragNet are warrantied to be free of manufacturer defect.

Download PDF