4. In order to proceed with the firmware update, the wheel must be put in BOOTLOADER mode
manually. Click OK and follow the onscreen instructions.
- Remove the USB plug from the computer.
- Simultaneously press buttons YELLOW and XBOX Guide (located on the racing wheel’s base),
then connect (without releasing YELLOW + XBOX GUIDE) the USB plug to the PC.
Upon reconnecting the wheel, you should notice that a Bulk driver has been installed.
This driver is required for the update process.
Once installed, the Device section should now indicate the boot state of the wheel.
When you are ready to continue, click OK.
IMPORTANT:
DO NOT UNPLUG your wheel from the USB port, and
DO NOT DISCONNECT the wheel’s power supply during the firmware update procedure.