Pyle PSLBRP4 User manual

Bird Repellent

User Manual

PSLBRP4

Installation:

1. Unlatch battery door on back of unit and remove battery compartment.

Install 4 x AA alkaline batteries. SEE FIGURE 1

2. Put 2 screws on the wall .To place unit onto wall, push double wall mount hanging holes onto the screws.

SEE FIGURE 2. For best detection; the unit should be positioned on the wall between 4.8 -14.2 feet above

the ground.

3. Locate function switch on the front of the unit to select the Day Mode and Night Mode. SEE FIGURE 3

FIGURE 1 FIGURE 2

FIGURE 3 FIGURE 4

4. Day Mold: Select the Day Mold, the unit working at the sound function only in day time. sound and flash

light will working same time in night time ,

Night Mold: Select the Night Mold, the unit will work in sound function only in day time and flash light

will working only in night time.

Note: If you are worried to make a noise to disturb people at night time, we suggest you select the

Night Mode. FIGURE 4

5. Avoid placing unit behind any large trees, wall or object

Caution:

● Continuously use the Animal Repeller

● If storms are expected remove the unit from outdoor areas

● Turn off the unit if pets are playing around the protection area

● The unit must not to be immersed in water or any other liquid

● Do no cover PIR sensor lens

● If cleaning is required, dampen a soft cloth with mild soap water.

Refrain from using any chemical or abrasive cleaning agents as this

might damage the function of the unit.