EN
26
Condition 1: Zero functions
When total sum of all loads on scale ≤4% of scale’s max. weight
capacity. (4%=80g when weight capacity is 2000g or 200g
when the weight capacity is 5000 g)
The LCD will show ”-----” or ”0g” each time the ZERO button is
pressed. Wait a moment if ”-----” appears on the display. ”0g”
and an ”o” icon at the same time in the corner of the LCD mean
the ”Zero” function is activated. Max. weight capacity remains
unchanged.
Condition 2: Tare function
When the total sum of all loads on the scale > 4% of the scale’s
max. weight capacity. (4 %=80g when the weight capacity is
2000g or 200g when the weight capacity is 5000g)
The LCD will show ”-----” or ”0g” each time the ZERO button is
pressed. Wait a moment if ”-----” appears on the display. ”0g” and
a (T) icon (tare) at the same time on the upper left corner of the
LCD mean the ”Tare” function is activated. Max. weight capacity is
reduced by the total weight of all loads.
Under this condition:
By pressing ZERO, you can see the total weight of all loads on the
scale. If you want to weigh more loads, just press ZERO to reset the
LCD reading to ’0’ again.
AUTO SHUT OFF
Auto shut-o occurs if display shows ’0’ or shows the same weight
reading for one minute.
g
ZE RO
g
ZE RO
g
g
g
g
g
g
1 min