Page is loading ...
03.26.15 | Rv3 | CC2105
INSTALLATION INSTRUCTIONS
Tops and Legs ship in separate cartons
1. Place the work surface upside down on a cardboard or carpeted surface to prevent finish from scratching.
2. Place the triangular Leg Plate on the top and slide beneath the Quick-Set Bracket in the direction shown in
Figure 1.
NOTE: A plastic or rubber mallet may be used to lightly tap the leg beneath the Quick-Set Bracket. In the
event that the triangular Leg Plate does not slide underneath the Quick-Set Bracket with light tapping
of the mallet, the screws identified “A” in Figure 1 below may be slightly loosened and then
retightened to enable the triangular Leg plate to slide beneath the Quick-Set Bracket.
Activity Tables
Figure 1
Use mallet here to lightly tap leg
plate beneath Quick-Set Bracket
Slide leg plate in this direction
Quick-Set Bracket
Leg Plate
“A” - (5 places)
03.26.15 | Rv3 | CC2105
INSTALLATION INSTRUCTIONS
3. With the Leg Plate now fully seated underneath the Quick-Set Bracket, install (3) Philips head, #10 x ¾” screws
provided in the hardware pack in the 3 holes identified “B” as indicated below in Figure 2.
4. Adjust leg to desired height by loosening the two 5/16” Philip Pan Head screws, sliding the leg insert in or out of
the receiver until the desired height setting is reached. Retighten the two 5/16” Philip Pan Head screws
ensuring that the corresponding holes in the Leg Insert aligns with the Philip Pan Head screws.
See Figure 3 below.
Figure 3
Figure 2
“B” - (3 places)
Philip Pan
Head Screws
Leg Insert
Leg Insert
adjustment holes
(1” increments)
Leg Receiver
/
