02.12.15 | Rv3
ALPHABET | INSTALLATION INSTRUCTIONS
Applicable Base Models:
ATT Tops
ATLI Leg Kits
1. Place the work surface upside down on a cardboard or carpeted surface to prevent finish from scratching
2. Align the leg assembly keyholes with the 4 shoulder screws as shown below in Figure 1.
3. With the I-Leg assembly now placed over the shoulder screws, slide the leg assembly in the direction indicated
below in Figure 2. (IMPORTANT – SEE NOTE ON REVERSE SIDE)
Under Seat Wire Book Basket
Table Tops and Leg Kits | I-Leg
Slide I-Leg Assembly
Start Position
Final Position
Figure 1
I-Leg Assembly Keyhole
Shoulder Screw
Figure 2
02.12.15 | Rv3
ALPHABET | INSTALLATION INSTRUCTIONS
NOTE: Some resistance sliding the I-Leg Assembly to its final position may be encountered. This should be
considered normal. Use of a plastic or leather mallet to aid assembly is permissible if used as shown
below in Figure 3.
4. Install the ¼-28 x 5/16” T-30, Torx head Lock Screw provided in the hardware kit with the T-30 Torx driver as
shown below in Figure 4.
5. Adjust leg to desired height. (Leg comes preset to a 29” table height)
Lock Screw
Figure 3
Figure 4
Use mallet here
/
