Ground
Ground
10
9
2
1
USB Connector Description
DIAGRAM
USB Negative Signal for Port 1
USB Positive Signal for Port 1
USB Power(+5V) for Port 1
KEY
VCC
Signal
Description
USB Ground
-D
+D
USB Power(+5V) for Port 2
USB Positive Signal for Port 2
USB Negative Signal for Port 2
NC
Signal
-D
+D
VCC
Description
USB Ground
1
2
9
10
Rear Left channel Audio Signal
Rear Right channel Audio Signal
Front Audio Ground
L-RET
NC
Key
Front Microphone Input Signal
Front Right channel Audio Signal
Front Left channel Audio Signal
Front Microphone Power
MIC Power
NC
R-OUT
L-OUT
Ground
R-RET
MIC IN
header by consulting your M/B manual to make installation correctly.
operate properly. Connect the 10-pin connector to your M/B USB
your M/B's USB header is for standard Intel USB description in order to
standard Intel connector based on Intel USB description. Be sure that
You will find a single 10-pin connector that marked "USB", which is a
connector may be inoperative.
instruction) If these jumpers are not installed, the M/B rear panel audio
M/B front panel audio header. (Please consult your M/B manual for
M/B front panel audio header, pins 5,6,9,10 should be jumped on the
This is a standard Intel Audio connector by following Intel Audio pin
description. If the front panel audio connector is not connected to the
Audio Connector Description
(b)Slide the drive into the tray on the side of the chassis,
Truss head screw
then fix the drive with screw .