meitav-tec CEO-24-HC22 Product information

Brand
meitav-tec
Model
CEO-24-HC22
Type
Product information
JP4
JP1
Date:
Title:
No.Revision Date File name: CEO-24-HC22.VSD
Drawn: P.Rechtman
Checked: M.Litovsky
Approved: E.Roy
CEO-24-HC22
30 May 2007
meitav-tec
Tel: +972-3-9636462
Fax: +972-3-9626620
e-mail: support@meitavtec.com
Print names: TELE/TOS
OUT-TEL24
W3 OUTOUT Y2 W2 Y1 G1 W1 MIL AL
24VAC
Alarm input 1
normally open
Alarm input 2 (N.O - 24VAC)
(Fault from system)
Alarm output (N.O. dry contact) –
activated when the temperature
reaches preset alarm limits or/and
when fault input from system is active.
Low voltage input to be utilized by the
W1 output (*jumper position dependent)
Heating 1st Stage
Fan
Cooling 1st Stage
Cooling 2nd Stage
Normally open, dry contact, general purpose output,
activated manually or by phone command (option).
Not in use
External sensor
Telephone line*
Heating 2nd Stage
Base plateFront plate
ON/STBY
ALARM
ON/OFF
SET
SET TEMP
PROG CLOCK SELECT MODE AUTO
FAN RESET
ALARM
LIMITS
Telephone line connection
BA
JP7
JP6
JP5
JP3
EC
JP1 (Base plate) *Position “3” - 24VAC to “W1” output. Position “1” - Voltage to “W1” output utilizes the voltage
applied to the “MIL” input. (Can be used to supply any low
voltage other than 24VAC)
JP1 (Front plate) *Position ”B” - Internal Sensor Position “A” - External sensor
JP3 *OPEN - 4 min Time Delay SHORT - Time Delay Off
JP4 OPEN - 24 Hrs. *SHORT - 12 Hrs. (AM/PM)
JP5 Not in use
JP6 *OPEN - “OUT,OUT” outputs not active SHORT - “OUT,OUT” outputs active
JP7 *OPEN - Fan - Electric mode SHORT - Fan – Oil/Gas mode
*Factory defaults
1
3
JP1 on front plate
(Internal/External sensor)
JP1 on base plate
(W1 output configuration)
JP1
  • Page 1 1

meitav-tec CEO-24-HC22 Product information

Brand
meitav-tec
Model
CEO-24-HC22
Type
Product information
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents