***READ ALL INSTRUCTIONS BEFORE USE***
MASTER BLASTER VARIABLE SPEED
PET DRYER
Model MB-3V
The AIR FORCE VARIABLE SPEED MASTER BLASTER is designed to
cut drying time by as much as 75%. The MASTER BLASTER provides
gentle heat and dramatic air velocity to dry Pets quickly and thoroughly.
1. Insert the grounded Power Supply Cord into a grounded outlet.
IMPORTANT: PRODUCT MUST BE GROUNDED.
WARNING: INPROPER CONNECTION OF THE EQUIPMENT GROUNDING CONDUCTOR
CAN RESULT IN A RISK OF ELECTRIC SHOCK!
2. Move car/motorcycle to a dry area to eliminate risk of electric shock.
3. Fit the 10 ft. by 1 ½” Hose (D) over the steel tube protruding from the front end cap
of the power unit. Tighten the adjustable clamp to keep the hose securely on the dryer.
4. Start the dryer by pushing the On/Off Switch (B) from left to right. Dry the vehicle
from top to bottom.
5. Attach or remove the Neoprene Nozzle, or other attachments from the hose to
control the air velocity.
6. For even greater air flow, the hose cuff on the blower end screws off in a counter
clockwise direction and screws back on in a clockwise direction.
7. Turn the Variable Speed Knob (F), and control your airflow from 0-100%.
SERVICE
NORMAL MAINTENANCE, SUCH AS MOTOR BRUSH REPLACEMENT, CAN BE MADE AT
YOUR LOCAL SERVICE SHOP. MOTOR BUSH LIFE IS APPROXIMATELY 500 HOURS.
BRUSHES SHOULD BE CHECKED BETWEEN 200-250 HOUR INTERVALS. SEE ENCLOSED
INSTRUCTIONS. FILTER LIFE IS DEPENDENT ON USAGE. CHECK AND REPLACE WHEN
REQUIRED.
CAUTION: DO NOT DROP THIS MACHINE. MOTOR MALFUNCXTION CAUSED BY
PRODUCT BEING DROPPED IS NOT COVERED UNDER WARRANTY.
DELIBERATELY MADE BETTER IN THE U.S.A®