Danfoss CF-RF Room Thermostat Installation guide

088U0213

GB

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

D

Instruktion CF-RF Raumthermostat mit Infrarot-Bodensensor

DK

Vejledning CF-RF Rumtermostat med infrarød gulvsensor

F

Instruction Thermostat d’ambiance CF-RF avec Capteur au sol infrarouge

SE

Bruksanvisning CF-RF rumstermostate med infraröd golvsensor

PL

Instrukcja obsługi termostatu z czujnikiem podłogowym CF-RF

NL

Handleiding voor CF-RF kamerthermostaat met infrarood vloersensor

I

Istruzioni CF-RF con sensore a pavimento a raggi infrarossi

1VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

GB

Instruction . . . . . . . . . . . . . . . . . . . . . . . 3

D

Instruktion . . . . . . . . . . . . . . . . . . . . . . 13

DK

Vejledning . . . . . . . . . . . . . . . . . . . . . . 25

F

Instruction . . . . . . . . . . . . . . . . . . . . . . 35

SE

Bruksanvisning . . . . . . . . . . . . . . . . . . 45

PL

Instrukcja obsługi . . . . . . . . . . . . . . . . 55

NL

Handleiding . . . . . . . . . . . . . . . . . . . . . 65

I

Istruzioni . . . . . . . . . . . . . . . . . . . . . . . . 75

2 VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

3VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

GB

Index

1. Functional Overview ...............................................4

2. Installation ...................................................................4

3. Temperature Settings ...............................................6

4. Transmission Test ......................................................9

5. Mounting .....................................................................9

6. Uninstallation ..........................................................10

7. Specications ........................................................... 11

8. Troubleshooting ...................................................... 12

9. Figures and Illustrations ................................ A1-A2

GB

4 VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

1. Functional Overview

Front - g. 1

Up/down selector

Push button

Red LED (behind the cover)

InfraRed oor sensor

LED modes

Permanent light

ON

No light

OFF

Slow ashing

Flashes

Fast ashing

Flickers

Back - g. 2

Back plate

Back plate lock/unlock (turn 90°)

Screw hole for wall mounting

Battery placement

Screw and wall plug

Note: To activate batteries please remove enclosed strips

from batteries

2. Installation

Note:

• To activate batteries in the Room Thermostat, please

remove enclosed strips from the batteries.

• The assignment of the Room Thermostats to the Master

Controller should be within 1½ m distance

5VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

Activate Install mode on Master Controller

- g. 1.

• Use the menu selection button

to select the

Install mode. Install LED ashes

• Activate Install mode by pressing OK

. Install

LED goes ON

Activate Install mode on Room Thermostat

• Press the push button

. LED and icker

during communication

Select output on Master Controller

• All available output LEDs on Master Controller

light up, and the rst of them ashes

• Press output selection button

, to select

desired output (ashes) and accept with OK

• All output LEDs go OFF. Selected output

stays ON shortly

Room Thermostat installation status

• Satisfactory - LED

goes OFF

• Not satisfactory - LED

ashes 5 times

Note: A Room Thermostat can be assigned to several

outputs if needed by repeating the installation process.

GB

6 VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

3. Temperature Settings

Digital Display - g. 1

Set value adjustment

Minimum temperature limitation

Maximum temperature limitation

Lock icon (settings locked from Remote

Controller, CF-RC)

Transmission link icon

Low battery indicator

Alarm icon

Timer icon (time program is active from

Remote Controller, CF-RC)

Room temperature

Floor surface temperature

Changing default display temperature - g. 1.

1. The actual room temperature is shown in the

display as default

2. To change default display from actual room

temperature to actual oor surface tempera-

ture, press and hold the push button

until SET MAX is shown in the display

3. Press the button

shortly and repeatedly

until

or is ashing in the display

4. Press the up/down selector to select the

new default display temperature:

Room temperature

Floor surface temperature

7VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

Setting of room temperature

1. Make sure actual room temperature is shown

in the display

2. Press the up/down selector to set the

desired room temperature value. SET is shown

in the display

3. When releasing the up/down selector the

display returns to actual temperature

Note: The thermostat regulates the oor heating system

according to room temperature set point, within the

maximum and minimum limitations dened for the oor

surface temperature

Room temperature limitation

1. Make sure actual room temperature is shown

in the display

2. Press the push button until SET MAX is

shown in the display

3. Press the up/down selector to set the

maximum room temperature limitation

4. Press the push button shortly, SET MIN is

shown in the display

5. Press the up/down selector to set the

minimum room temperature limitation

6. Press the push button shortly and the

actual oor surface temperature is shown in

the display

GB

8 VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

Floor surface temperature limitation

1. Ensure actual oor surface temperature is

shown in the display illustrated by

2. Press and hold the push button until SET

MAX is also shown in the display

3. Press the up/down selector to set the

maximum oor surface temperature limitation

4. Press the push button shortly, SET MIN is

also shown in the display

5. Press the up/down selector to set the mini-

mum oor surface temperature limitation

IMPORTANT!

As heat emission from the oor may vary slightly

depending on oor covering - and thereby cause

inaccurate temperature measurement - it may be

necessary to adjust the setting of max. and min.

oor surface temperatures accordingly.

! It is important always to follow recommendations

from the oor manufacturer regarding max. oor

surface temperature.

! It is recommended always to include mixing shunt

for oor heating circuits in order to ensure optimal

ow temperature. - In addition to minimised energy

consumption, correct setting of the ow tempera-

ture will eliminate the risk of excessive heat transfer

to the oor.

9VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

4. Transmission Test

Initiate transmission test on Room Thermostat

- g. 1

• Press the push button

• LED goes ON

Link test is satisfactory

• LED

goes OFF

Link test is unsatisfactory

• LED ashes 5 times

No link connection to Room Thermostat

• Try to relocate Room Thermostat in the room

• Or install Repeater Unit (CF-RU) and locate

between Master Controller and Room

Thermostat

Note: Master Controller output LED(s) connected to the

Room thermostat, ash(es) during link test

5. Mounting

Placing the Room Thermostat - g. 3

• The Room Thermostat should be placed in

accordance with g. 3

IMPORTANT!

Wherever possible, the room thermostat should

be installed at a place where the eect of sunlight,

GB

10 VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

strong articial light (e.g. halogen spotlight),

draught, other heat-emitting equipment (e.g. TVs)

etc. is avoided.

! Please note that no furniture, rugs etc. should be

permanently placed within the area of the InfraRed

Floor Sensor as shown in g. 3.

Mounting - g. 2

1. Mount the back plate

with the two screws

and wall plugs

via the screw holes in the

back plate

2. Slide thermostat into place on the back plate

3. If desired lock the thermostat to the back plate

with Allen key

(turn 90°)

6. Uninstallation

Activate Uninstall mode on Master Controller

- g. 1

• Use the Menu selection button

to choose

the Uninstall menu. Uninstall LED

ashes

• Activate Uninstall mode by pressing OK

.

Uninstall LED goes ON

Deselect output on Master Controller

• Select output to be removed by output selec-

tion button

• Remove ashing output with OK

11VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

7. Specications

Temperature setting range 5-35°C

Transmission frequency 868.42MHz

Transmission range in normal

buildings (up to)

30m

Transmission power < 1mW

Battery Alkaline 2xAA, 1.5V

Battery lifetime (up to) 1-3 years

Ambient temperature 0-50°C

IP class 21

Floor ensor accuracy +/- 1°C

Floor sensor emission

coecient

0.9

GB

12 VI.UH.R2.1C Produced by Danfoss Floor Heating Hydronics 03.2007

Instruction CF-RF Room Thermostat with Infrared Floor Sensor

Error Indication Possible Cause

The LED, and

ashes every 5th minute

Low battery

The LED, and

ashes every 30 sec.

Critical low battery

The LED, , and

ashes

Critical low battery -

transmission has stopped

The LED, and

ashes 5 times

Installation/link Test is

unsatisfactory

E03 and

Actuator error on output

(CF-MC)

E05 and

Room temperature below

5°C

8. Troubleshooting

Page is loading ...

VI.UH.R2.1C Produit par Danfoss Floor Heating Hydronics 03.2007

9. Figures et illustrations .................................... A1-A2

1. Présentation des fonctions .................................

36

2. Installation ................................................................ 36

3. Réglages température ......................................... 38

4. Test de transmission ..............................................41

5. Montage .................................................................... 42

6. Désinstallation ........................................................ 43

7. Spécications ........................................................... 43

8. Dépannage................................................................ 44

35

Instructions Thermostat d’ambiance CF-RF avec Capteur au sol infrarouge

F

Index

Page is loading ...

Handleiding voor CF-RF kamerthermostaat met infrarood vloersensor

VI.UH.R2.1C Geproduceerd door Danfoss Floor Heating Hydronics 03.2007

NL

65

NL

Inhoud

9. Afbeeldingen ..................................................... A1-A2

1. Functies overzicht ...................................................

66

2. Installatie/aanmelden .......................................... 66

3. Temperatuurinstellingen ...................................... 68

4. Verbindingstest ..................................................... 71

5. Montage ..................................................................... 72

6. Afmelden / resetten ............................................... 72

7. Specicaties ..............................................................73

8. Probleemoplossing ................................................ 74

Page is loading ...

Handleiding voor CF-RF kamerthermostaat met infrarood vloersensor

VI.UH.R2.1C Geproduceerd door Danfoss Floor Heating Hydronics 03.200774

8. Probleemoplossing

Foutmelding Mogelijke oorzaken

De led, en knipperen

om de 5 minuten

Batterij bijna leeg

De led, en knipperen

Batterij op kritisch peil

De led, , en

knipperen

Batterij op kritisch peil

– transmissie gestopt

De led, en knipperen

5 keer

Aanmelden/Verbin-

dingstest niet gelukt

E03 en

Motorfout op uitgang

(CF-MC)

E05 en

Kamertemperatuur

lager dan 5°C

Page is loading ...

Danfoss CF-RF Room Thermostat Installation guide

Danfoss CF-RF Room Thermostat Installation guide

in other languages

Related papers

Other documents