Custom Building Products LQWAF1 Operating instructions

Type
Operating instructions

This manual is also suitable for

REDGARD
®
EXCEEDS THE REQUIREMENTS FOR
WATERPROOFING STEAM SHOWERS
TB63
RedGard
®
Exceeds the Requirements as a Low Perm
Waterproofing Membrane for Continuous Use in
Steam Showers
Tile installers are familiar with what happens in the wall cavity
and rooms adjacent to steam showers when they have not
been properly waterproofed. Water and steam damage can
result in expensive repairs to both the steam shower and the
surrounding rooms. The responsibility for water vapor damage
has typically fallen on the tile installer, who did everything
right based on the information he was given. In 2010, tile
installers from the NTCA asked for a better standard regarding
steam showers to ensure that moisture would not move
through these tile installations and into walls.
TCNA formed a committee of membrane manufacturers to
evaluate the problem and develop a solution. The committee
found that significant moisture vapor could make its way into
the wall cavity. It was determined that both water movement
and moisture vapor movement had to be controlled. Mem-
branes that meet the requirements of ANSI A118.10 will control
the water movement, but the requirement does not define their
resistance to moisture vapor transmission.
The committee determined that the industry needed a definition
for low perm waterproofing membranes. ASTM E96 addresses
the allowable amount of water vapor transmission measured
in perms, a unit of permeance. In 2013, this definition was
added to require that low perm waterproofing membranes
must meet the requirements of ANSI A118.10 and have a
moisture vapor transmission less than 0.5 perms when
tested to ASTM E96, using Method E (tested at 100ºF and
90% relative humidity).
Testing reveals that Custom Building Products RedGard
®
Liquid
Crack Prevention and Waterproofing Membrane exceeds the
TCNA requirement for a low perm waterproofing membrane.
RedGard is suitable for surface waterproofing of floors, walls
and ceilings in continuous use steam showers. Third party
testing shows that a 30 mil dry film of RedGard has a perm
rating of 0.36 when tested to ASTM E96 Method E.
CUSTOM RedGard Liquid Crack Prevention and Waterproofing
Membrane offers the convenience of a liquid applied solution
to contain both water and moisture vapor.
©2014 1/14N
Technical Services 800-282-8786
custombuildingproducts.com
Technical Bulletin
The information in this bulletin is presented in good faith, but no warranty,
express or implied, is given nor is freedom from any patent in as much as
any assistance furnished by CUSTOM with reference to the safe use
and
disposal of its products provided without charge. Custom Building Products
assumes no obligation or liability therefore, except to the extent that any such
assistance shall be given in good faith.
  • Page 1 1

Custom Building Products LQWAF1 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI