ULTIMATE MP Instruction Sheet
Directions:
1. Surfaces must be cleaned down to the original substrate and free
from any material that may prevent adhesion.
2. Remove nozzle and cut tip of nub.
3. Puncture foil seal.
4. Screw nozzle onto cartridge and cut tip on slant for a 1/4” to 3/8”
bead.
5. Place in cartridge gun.
6. Force sealant into clean joint. Always apply sealant in bead form.
To ensure neat sealant lines, mask areas adjacent to joints. Once
sealant is dry to the touch and does not transfer, remove masking
tape. It is the sole responsibility of the user to thoroughly test any
proposed use with all substrates to determine project suitability.
See titebond.com for full TDS and MSDS information.
/
