ESAB HC-6 Hand Control Installation guide

Brand: ESAB

Model: HC-6 Hand Control

Type: Installation guide

DESCRIPTION

refer to Figure 1

The HC-6 Hand Control is designed for use with power

sources such as the Migmaster 300i cvcc. The HC-6

consist of a two button control box assembly, 25-ft. cable,

remote control male amphenol plug (P1) and remote

contactor female amphenol plug (P2).

INSTALLATION

refer to Figure 1

Make sure that all primary power to the power source

is disconnected before beginning installation of this

equipment.

Insert main control plug P1 into the J2 remote recep-

tacle on the front panel of the power source. If you are

using a remote contactor switch, insert the amphenol

HC-6 Assy.

Remote Contactor Switch

(i.e. HW-17TV-2)

POWER

SOURCE

Remote

RAISE

LOWER

Installation and Operating Instructions for

F-15-137

May, 1997

HC-6 Hand Control

P/N 21225

plug from the remote contactor switch assembly into the

HC-6’s P2 plug.

OPERATION

The HC-6 Hand Control contains two push buttons, Raise

and Lower. These push buttons allow remote control of

all the functions that are normally associated with the

arrow keys on the power source Control Panel.

The Raise and Lower push buttons can be used to in-

crease and decrease the following:

Mig functions such as wire feed speed trim, or power

source inductance.

Tig welding current.

Stick welding current.

These adjustments can be made while welding, before

welding or after welding.

F-15-137 5/97

Figure 1. Interconnection Diagram

ESAB HC-6 Hand Control Installation guide

ESAB HC-6 Hand Control Installation guide

ESAB HC-6 Hand Control Installation guide

Related papers

Other documents