How to apply Cool Roof coatings: 3 easy steps
1 2 3
STEP 1: CLEAN THE SURFACE
Clear roof surface of loose debris
including dirt, gravel, sticks, etc. using
a push broom or blower. Wash away
surface dirt with a pressure washer.
STEP 2: REPAIR & REINFORCE
Patch and repair cracks, blisters and
other problem areas using roof patch
following label
directions. Reinforce
with Universal Patching fabric.
STEP 3: APPLY COOL ROOF COATING
On a clear, warm, sunny day (65 F and
rising), apply Elastomeric Roof Coating
to a dry roof surface. Cut in along
edges, then move from one end of the
roof to the other keeping a continuous
wet edge. Follow all label directions.
RECOMMENDED SURFACES
RECOMMENDED APPLICATORS COVERAGE: 2 COATS RECOMMENDED
• Metal
• Urethane/polystyrene foam
• Concrete roofs
• Aged roll roofing, existing
aluminum & white coatings
• Flat and barrel cement tile
Patching material: brush or trowel
as indicated on container instructions.
Elastomeric coating: Roof brush,
¾” nap roller, or airless spray in 10”-
12” pattern, 2000 psi, .021 to .025
spray tip
Metal
Porous surfaces including
foam, concrete, tile, roll
roofing, and previously
coated surfaces
80-100 sq
ft./ gal
50-75 sq.
ft./gal
PROJECT HOW-TO’S™ COPYRIGHT © 2008, 2009, 2010-2012 GARDNER-GIBSON,
INC.
-
1
Gardner SK-4401 Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Crossco RS106-02 Operating instructions
-
Master VV1247 Operating instructions
-
-
Ames BMX1TG Specification
-
-
-
-
-
ANViL ROOF-TEC 122004 Installation guide
-
