2. Neff
  3. D95DAP8N0B
D95DAP8N0B

Neff D95DAP8N0B, HNF2904 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Neff D95DAP8N0B Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Neff Downdraft Hood & Hob
950mm Island Application
Installation - 950 Breakfast Bar
Installation - Cabinet modification
1
LEAFHDE
Cut the aperture in your breakfast bar following the dimensions below.
Note: The minimum dimension between the apertures should be 60mm, however we recommend 85mm to give space for drawer
applications to be fitted to the front cabinet.
Rebate the cut out and apply the seal as shown below.
2
For a breakfast bar thickness below 38mm, the base of the cabinet will need to be cut out for the bottom of the hood to fit into.
This cut out will be directly below the breakfast bar cut-out once fitted located in the base panel of the wall unit.
Follow the dimensions shown for this application.
Cabinets (both base and wall) will require the back panels cutting in order to fit the
electric and motor boxes of the hood. See cut out dimensions below.
HD917022
This leaflet shows how to cut the aperture in the worktop
and cabinet (where required) to suit the installation of the appliances.
This product installation is only suitable for an island application.
85mm
(60min)
104mm
100mm
844mm
Hood Cut out
Hob Cut out
85mm
(60min)
118mm
100mm
104mm
844mm
Fit adhesive strip
around the rebate
Installation shows the use of a base cabinet with 290mm depth
wall cabinet (back to back)
Base cabinet - base panel cut out
(only required when worktop thickness is below 38mm)
Follow the appliance fitting instructions (supplied
with the appliance), for all other aspects of installation.
The kitchen installation manual should
be followed for all aspects of cabinet and worktop installation
Cabinet back panel cut-out
(Required for hood motor and electrical box)
Cabinet configuration is base and wall back to back
922mm
6mm
39mm
3mm
790mm
390mm
HD917022
3
Use chipboard offcuts to create filler panels to cover gap in service void between the back of the back and wall cabinets,
(x2 - 406mm x 92mm, x2 - 790mm x 92mm) and secure using angle brackets and fixing plates (not supplied).
4
Fit hood into worktop aperture ensuring the motor box and electrics are not attached to the hood body at this point
Fix to base of wall cab using 2x lower mounting brackets supplied with the hood (follow appliance instruction manual).
Note: Top mounting brackets cannot be fitted due to restricted access.
5
Loosely fit motor box to front of hood body, mark and cut aperture for exhaust ducting as required (typically out the base of the cabinet).
Refit and tighten motor box to hood body. Fit ducting to motor box as required.
Finally connect eectrics and test the appliance. Follow the instruction booklet supplied with the product for all other aspects
of product installation and use.
790mm
Chipboard filler
rails to box in service void
406mm
Hood
Motor Box
/