2. Dogberry
  3. w-xbar-1460-whit-none
w-xbar-1460-whit-none

Dogberry w-xbar-1460-whit-none Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Dogberry w-xbar-1460-whit-none Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Suggested Shutter Installation Instructions
1. Parts included with your order:
• 2 shutters
• 10 fasteners (5 for each shutter)
• 10 wall anchors (5 for each shutter)
2. Gather required tools:
• Pencil or pen
• Tape measure
• Hammer
• Drill
• Phillips bit
• 1/16” bit and 1/4" bit
3. Read all instructions before proceeding. Then determine location of shutters on wall, spacing as desired.
4. Hold one shutter at a time in the desired location, and use 1/16” bit to pre-drill 5 holes through each
shutter AND into the wall. Optimal hole locations may vary depending on your specific project.
5. Set shutters aside for a moment, and use 1/4” bit to drill into holes in the wall from the previous step.
This will widen the holes in the wall sufficiently to accept wall anchors.
6. Use a hammer to lightly tap all 10 wall anchors into holes until flush with the surface of the wall.
7.
Final step:
Hold shutters so holes
align with wall anchors,
and use Phillips bit to
install fasteners into
wall anchors.
Countersinking is
recommended if you
prefer fasteners to be
flush with exterior
surface of shutters.
WARNING: This product can expose you to Formaldehyde (gas), Carbon Black (airborne, unbound particles of respirable size), N- methylpyrrolidine, Cumene, Ethylene glycol (ingested), and Toluene,
which are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to: www.p65warnings.ca.gov.
/