THANK YOU

We appreciate the trust and condence you have placed in Glacier Bay through the purchase of this adjustable tension curved shower rod.

We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products

available for your home improvement needs. Thank you for choosing Glacier Bay!

USE AND CARE GUIDE

ADJUSTABLE TENSION CURVED SHOWER ROD

Questions, problems, missing parts?

Before returning to the store, call Glacier Bay Customer Service

8 a.m. - 6 p.m., EST, Monday - Friday

□ Read through this entire manual prior to assembly and installation.

All costs of removing and reinstalling the product are the purchaser’s responsibility. Any alteration of this product or use of this product

in any manner other than its intended use is not covered by this warranty. The manufacturer assumes no responsibility whatsoever for

product installation during the limited lifetime warranty.

The manufacturer disclaims any and all warranties. The duration of any implied warranty which cannot be disclaimed is limited to the

time period as specied in the expressed warranty. The manufacturer shall not be liable for incidental, consequential, or special damages

arising out of or in connection with product use or performance except as may otherwise be accorded by law. This warranty gives

specic rights, and you may have other rights which vary from state to state.

To obtain warranty service, call our customer service department at 1-855-HD-GLACIER for return authorization and shipping instructions

so that we may repair or replace the product. No warranty claim will be processed without a copy of the receipt as proof of purchase.

AA Plastic rings 2 EE Rod set screw 1

BB Mounting bracket screws 2 FF Large hex wrench 2

CC Threaded inserts 2 GG Medium hex wrench 1

DD End cap set screws 4 HH Small hex wrench 1

HH

B

D

□ Slide the end cap (E) onto the 7/8 in. diameter tube

□ Fasten the end cap (E) to the mounting bracket for the

□ With the arrows on the mounting bracket for the 7/8 in.

diameter tube (B) pointing up and down, fasten the 7/8 in.

diameter tube assembly (C) to the mounting bracket for

the 7/8 in. diameter tube (B) using mounting bracket screw

(BB) and threaded insert (CC). Tighten using the large hex

wrenches (FF).

□ Repeat this step for the 1 in. diameter tube (D).

BB

CC

C

□ Lock the length of the assembly with the rod set screw (EE)

tub opening

secure the rod into place.

□ Cleaning with a dry cloth may be sufcient.

□ For other stains or marks, wipe gently with a damp cloth.

□ Do not use strong detergents or abrasive cleaners; they may damage the surface of this product.

□ Twist the tube towards you or away from you to make the rod longer or shorter.

□ After the end caps are touching your walls, turn the 7/8 in. diameter tube assembly (C) two and a half times to tighten the rod in place.

to extend the rod to shorten the rod

C