Stucco Mesh
Reinforcing Mesh
DESCRIPTION:
n Woven fiberglass standard mesh for
reinforcement of stucco assemblies.
n
4.5 oz. fiberglass 38 in. (96.5 cm) mesh.
n
Highly flexible for full walls or details.
n Alkali-resistant.
USES:
n
Embed in stucco base coats for increased
crack resistance and strength.
n
Use with Krak-Master and Krak-Shield
stucco assemblies.
n Not for use on Exterior Insulation and
Finish Systems (EIFS).
SPECIFICATIONS:
n Weight: 4.5 oz./yd
2
(153/g/m
2
)
n
Width: 38 in. (96.5 cm) x 150 in. (381 cm)
n Packaging: 4 rolls/box
n Color: Green
COVERAGE:
475 ft
2
(43.6 m
2
)/roll
STORAGE:
Avoid storing rolls on end or in direct sunlight.
APPLICATION:
n
Embed the Stucco Mesh in Parex USA
Stucco Level Coat and/or as close to the
surface as possible.
n
The color of the reinforcing mesh
should not be visible at the surface of
the level coat. A slight pattern of the
mesh is acceptable, due to shrinkage of
the cementitious Base Coat upon drying.
n
Stucco Mesh must be continuous at all
corners and must be lapped a minimum
of 2-1/2 in (63.5 mm) at the mesh seams.
LIMITATIONS:
n
Not for use on Exterior Insulation and Finish
Systems (EIFS).
WARNING:
n
This Product Data Sheet has been prepared
in good faith on the basis of information
available at the time of publication. It is
intended to provide users with information
about the guidelines for the proper use
and application of the covered product(s)
under normal environmental and working
conditions. Because each project is different,
Parex USA, Inc. cannot be responsible for
the consequences of variations in such
conditions, or for unforeseen conditions.
© Parex USA, Inc. August 2011 • PUSASMDS
Facilities
Anaheim, CA
French Camp, CA
North Hollywood, CA
Riverside, CA
Colorado Springs, CO
Corporate Office
Parex USA, Inc.
4125 E. La Palma Ave., Suite 250
Anaheim, CA 92807
(866) 516-0061
Tech Support: (800) 226-2424
Z Z Z S D U H [ X V D F R P
Fort Pierce, FL
Dalton, GA
Redan, GA
Albuquerque, NM
Wilkes Barre, PA
San Antonio, TX