2. Rosemount
  3. Removing Junction Box from a sensor and

Rosemount Removing Junction Box from a sensor and Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Rosemount Removing Junction Box from a sensor and Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Reference Manual
00809-0200-4725, Rev AA
November 2011
Rosemount 8732E
www.rosemount.com
Removing the Junction Box from a Sensor (Rosemount 8705 or
8711) and Installing the Rosemount 8732E Integral Transmitter
Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 1
Step 1: Remove bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 1
Step 2: Remove junction box . . . . . . . . . . . . . . . . . . . . . .page 2
Step 3: Insert wire harness pins . . . . . . . . . . . . . . . . . . . .page 2
Step 4: Tighten the terminal block screws . . . . . . . . . . . .page 3
Step 5: Position the transmitter . . . . . . . . . . . . . . . . . . . .page 3
Step 6: Reinstall bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . .page 4
The following Manual Supplement contains step by step instructions for
removing the junction box from a sensor (Rosemount 8705 or 8711) and
installing a Rosemount 8732E integral transmitter.
Tools Required •
3
/16-in. bent allen wrench
• Small slot tip screwdriver
Step 1: Remove bolts Using the allen head wrench, remove the four bolts holding the junction box
onto the sensor. Set the bolts aside for later use.
Reference Manual
00809-0200-4725, Rev AA
November 2011
Rosemount 8732E
2
Step 2: Remove junction
box
Remove the junction box exposing the terminal block of the sensor. Note that
there is an o-ring in a retaining groove on the pedestal of the sensor. Make
sure that the o-ring stays in place.
NOTE
Make sure the terminal block openings are all the way open.
Step 3: Insert wire
harness pins
Position the transmitter to allow for the insertion of the wire harness pins to be
installed into the terminal block of the sensor.
Reference Manual
00809-0200-4725, Rev AA
November 2011
3
Rosemount 8732E
Step 4: Tighten the
terminal block screws
While supporting the 8732 transmitter, use a small slot tip screwdriver to
tighten the screws of the terminal block securely.
Step 5: Position the
transmitter
With the wire harness attached, position the transmitter over the sensor and
set upon the sensor. Make sure that the o-ring is properly seated in the
retaining grove to prevent it from being pinched.
Reference Manual
00809-0200-4725, Rev AA
November 2011
Rosemount 8732E
4
Step 6: Reinstall bolts With the transmitter in position, use the allen head wrench to reinstall the four
bolts set aside in Step 1.
After all four bolts are installed and tightened, the installation is complete.
Please refer to the Quick Installation Guide (00825-0100-4727) for instruction
on grounding, powering, and configuring the transmitter.
/