Ford 2018 Mustang User manual

7/18/22, 11:23 AM

Direct-Hit -- Search

https://dh.identifix.com/SearchFixes/Index?ROID=322301968&VID=2501304&VSM=4&HasBookmark=0&LocationId=2&WorkflowPath=1&KW=cranks…

1/1

Removal and Installation: Cra...

303-14B Electronic Engine Controls - 5.0L Ti-VCT V8 (308kW/418PS) 2018 Mustang

Removal and Installation Procedure revision date: 09/18/2017

Crankshaft Position (CKP) Sensor

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Remove the intake manifold.

Refer to: Intake Manifold (303-01B Engine - 5.0L Ti-VCT V8 (308kW/418PS), Removal and Installation).

2. Position the cover and disconnect the CKP sensor electrical connector, remove the bolt and the sensor.

Torque: 89 lb.in (10 Nm)

Installation

1. To install, reverse the removal procedure.

2. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.

This publication contains material that is reproduced and distributed under a licence from Ford Motor Company. No further

reproduction or distribution of the Ford Motor Company material is allowed without the express written permission of Ford Motor

Company.