BATTERY COVER
INSTRUCTION MANUAL
RED BLUE WHITE
Flashing LEDs Lights On/O
Indicator Light
Swing Arm Up
Forward/Backward Turn Left/Turn Right
Red, Blue, & White LED Lights
Function Demonstration Programming
Swing Arm Down
Quick Start Guide
1. Turn on the AtomicX RC stunt car (on/o button can be found on the
bottom of the car).
2. Turn on the remote transmitter.
3. Press the Function Demonstration button on the remote to start.
Programming Instructions
1. Press the Programming button on the remote to start setting up a series of
stunt RC car stunts.
2. Use the buttons and toggles to program your desired sequences (Program
up to 30 actions).
3. Press the Programming button again to nish programming. Watch your
RC car perform all the programmed stunts one after another, all on its own.
REMOTE CONTROLLER USES 2X 1.5V AA BATTERIES.
(Batteries not included)
Safety Reminders
1. Regularly check all electronic components. Discard if damage occurs.
2. This RC car has fast moving parts. Keep hands, hair, other body parts, and
clothing away from moving parts to avoid accidents.
3. DO NOT attempt to charge non-rechargeable batteries.
4. Properly dispose old batteries following local laws and regulations.
5. Install batteries according to correct polarity as shown in the battery
compartment.
6. Remove exhausted batteries from the toy.
7. DO NOT short circuit terminals.
8. DO NOT mix old and new batteries.
9. Remove batteries when not in use.
10. DO NOT leave charging batteries unsupervised.
11. DO NOT overcharge batteries. Max charge time: 2 hours.
12. Store batteries in cool, dry place. Keep batteries out of direct sunlight and
from moisture.
REMOTE ATOMICX RC CAR
Questions? Comments? Suggestions? Feel free to contact us at support@force1rc.com.
6+
Pairing Instructions:
1. Turn on both the car and the remote.
2. The indicator light on the remote control will ash then turn o to signal
successful pairing.
3. If the indicator light on the remote ashes but does not turn o, pairing is
unsuccessful.
4. When this happens, turn o both the remote and the car then turn them on
again until they are successfully paired.
OPEN THE BATTERY COMPARTMENT COVER AND
INSTALL BATTERY WITH CORRECT POLARITY.
USB CHARGING CABLE
/
